485788
12
Zoom out
Zoom in
Vorherige Seite
1/32
Nächste Seite
EN-4
OPERATION
1. POWER ON/OFF
By pressing this key, the unit is switched on or off. This unit is turned on by pressing any key.
2. SELECT
3. VOLUME UP/DOWN
TurningtheVOLknobRightorLeft(3),youcanadjustVOL/BASS/TREB/BAL/FAD.Toselectotherfunctions,press
the “VOL” knob shortly until the desired functions is shown on the display. Figure 1 shows how control functions are
selected using the “VOL” knob.
1 3
2
4
2
5
2
6
2
2
Fig. 1 Selection of sound control functions
1. VOL 2. SEL 3. BAS 4. TRE 5. BAL 6. FAD
Turning the VOL knob Right or Left. Increase or decrease the volume by turning
VOLVOL
or
VOLVOL
. These buttons can
beusedtoadjusttheBASS,TREBLE,BALANCEandFADER.
IN VOL
SEL
2 sec.
SEL
ADJ
SEL
TA VOL
SEL
EON
SEL
DSP
SEL
TA SEEK
SEL
PI SOUND
SEL
MASK DPI
SEL
RETUNE
Press and hold VOLknobtoadjustINITVOL/ADJ/TAVOL//DSP/TASEEK/PISOUND/RETUNE/MASKDPI
IN VOL
CanadjustInitialVolumelevelusingthismode.
ADJ
Canadjustclocktime.TurnVOL knob clockwise to set hours and counter clockwise to set minutes.
TA VOL
CanadjustTAVolume(ThevolumelevelwhenTrafcannouncementistransmitted).
EON
Can selected EON condition, ON or OFF.
DSP
Can select DSP mode (Classic, POP, Rock, Flat)
TA ALARM/SEEK
TA SEEK mode:
WhennewlyturnedstationdoesnotreceiveTPinformationfor5sec.,theradioretunestonextstationwhichhas
not the same station (PI) as the last station, but has the TP information.
In TA seek mode, the current station can be changed to the completely different station because the unit searches
TPstationwhentheeldstrengthofthecurrentstationisveryweak,orthecurrentstationhasnoTPsignal.
TA ALARM mode:
Anyautomaticretunemodeisnotactivated,justcanhearBeepsound.
PI MUTE/SOUND
Actionwhen2stationswithdifferentprogrammeidentication(PI)codesareonthesamefrequency:
SOUND: The radio switches to the new channel for a few seconds and then switches back again
MUTE: The radio is muted
RETUNE L/S
RETUNE L: Select 90 seconds as the initial time of automatic TA search.
RETUNE S: Select 30 seconds as initial time.
MASK DPI/ALL
MASK DPI: masked only the AF which has different PI.
MASK ALL:maskedtheAFwhichhasdifferentPIandNORDSsignalwitheldstrength.
4. PRESET STATIONS (1,2,3,4,5,6)
When pressed momentarily, these keys select a preset station directly. When pressed longer than 1 sec., current
station is stored in preset memory bank.
USING THE RDS FUNCTION
What is RDS?
The RDS (Radio Data System) is a digital information system developed by the EBU (European Broadcast Union).
Piggy-backed on normal FM broadcasts, RDS offers a variety of information services and automatic retuning functions
for RDS-compatible car stereos.
In 1988, RDS became available in the United Kingdom, France, West Germany, Ireland and Sweden. Test transmis-
sionsarebeingconductedinmanyotherEuropeancountries.ItisexpectedthatRDSwillbeavailableinmostwestern
European countries in the near future.
12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Tokai LAR-352 B wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info