50 Toledo
SPARE PARTS LIST TBS-800
REF NR DESCRIPTION TOLEDO NR
01 +02 CARBON BRUSH HOLDER 409000
03 + 04 CARBON BRUSH SET 409001
05 BELT WHEEL 409002
06 BEARING 608-2Z 800608
08 ROTOR 409003
16 STATOR 409004
17 BEARING 626-2Z 800626
21 + 50 NEEDLE BEARING HK081210 801211
22 SPINDLE 409005
23 ROLL 409006
26 SWITCH 409007
31 BASE PLATE 409008
41 BELT WHEEL 409009
43 + 45 BEARING 627-2Z 800627
44 SPIRAL GEAR 409010
47 BIG GEAR 409011
53 DRUM 409012
55 ADJUSTING KNOB 409013
73 BELT COVER 409014
67 + 68 DUSTBAG COMPLETE 409015
61 DRIVING BELT 409016
ELECTRICAL SAFETY
Always check that the power supply corresponds
with the voltage on the rating plate.
The machine is double insulated in accordance with
EN-50144; therefore no earth wire is required.
Replacing cables or plugs
Immediately throw away old cables or plugs when they
have been replaced by new ones. It is dangerous to insert
the plug of a loose cable in the wall outlet.
Using extension cables
Only use an approved extension cable suitable for the
power input of the machine. The minimum conductor
size is 1.5 mm
2
. When using a cable reel always unwind
the reel completely.
OPERATION
Always observe the safety instructions and applica-
ble regulations.
CHOICE OF THE SAND-PAPER
Coarse sand-paper (grain 50) removes in general the big-
ger part of the material and fine sand-paper is used for the
finishing. If the surface is not even, then start with rough
sand-paper. Further you use middle coarse sand-
paper(grain 80) to remove the scratches left behind by
the coarse sand-paper and finally you take fine sand-
paper (grain 120) for the finishing.
REMOVING AND INSTALLING THE SAN-
DING BELT
Before assembly the sanding belt always remove
the plug from the mains.
• Put the machine on its side, with the drive belt cover
(10, Fig. A) down wards.
• Loosen the sanding belt fastener (7, Fig A).
• Remove the sanding belt from the machine
• Put a new sanding belt on the machine, make sure
that the direction arrows on the sanding belt are
pointing in the same direction as the direction indica-
tor (9, Fig. A).
• Fasten the sanding belt fastener again (7, Fig. A).
ALIGNING THE SANDING BELT
If the sanding belt doesn’t run parallel with the outer
edge of the housing, the sanding belt must be aligned.
Move the sanding belt in the correct position with the
adjusting knob (6, Fig. A). By turning the adjusting knob
clockwise the sanding belt will move to the inside and by
turning anti-clockwise the sanding belt will move to the
outside.
SWITCHING ON AND OFF
• To switch the machine on press the on/off switch (1,
Fig. A).
• To switch the machine off release the on/off switch
(1, Fig. A).
If continuous operation is required the blocking
switch (4 fig. A) must be used:
• Switch the machine on to press the on/off switch.
• Press the blocking switch (4, Fig. A) and release the
on/off switch.
• To switch the machine off press the on/off switch
again and release the on/off switch.
MOUNTING DUST BAG
Use the dust bag to collect dust which is released during
sanding.
• Put the dust bag on the dust collection opening (5, Fig.
A).
• Empty the dust bag regularly in order to obtain an effi-
cient dust extraction.
Toledo 3
