Bedienungsanleitung Tommee Tippee Digital Ear thermometer (Seite 1 von 3) (Englisch)

693095

Zoom out

Zoom in

Vorherige Seite

1/3

Nächste Seite

On/Mem

1 2

HYGIENE

COVER

CONNECTION

RING

°C

The LCD screen will light up automatically after pressing the scan button, and will automatically turn

oﬀ after 5 seconds.

8. The temperature will show clearly on the LCD display.

9. To power oﬀ, hold down the ‘On/Mem’ button for approximately 5 seconds, until the LCD screen

shows ‘o’. The thermometer will automatically shut down after 1 minute if it is not turned oﬀ,

prolonging the battery life.

FEVER ALARM

If the thermometer detects a body temperature ≥37.5°C (99.5°F), one long beep will sound followed

by three short beeps to warn the user of potential fever.

SWITCHING BETWEEN FAHRENHEIT (°F) AND CELSIUS (°C)

1. In ‘Power oﬀ’ mode, press and hold the ‘Scan’ button.

2. Then press the ‘On/Mem’ button for 3 seconds whilst still holding the scan button. The ‘°C’ will

change to ‘°F’. You can use the same process to change from ’°F’ back to ‘°C’.

MEMORY FUNCTION

1. Press the ‘On/Mem’ button again to see the last temperature stored.

The thermometer will automatically save the last reading into the memory, if it is within the

temperature range of 34°C to 42.2 °C (93.2 °F to 108.0°F).

CLEANING AND STORAGE

The probe is the most delicate part of the thermometer. When cleaning the lens handle with care to

avoid damage. If device is accidentally used without hygiene cover, clean the probe as follows:

1. Use a cotton swab (Alcohol 70% concentration) to clean the lens found inside the probe.

2. Allow the probe to fully dry for at least 1 minute.

The thermometer should be stored at temperature between -20°C to +50°C.

Keep the unit dry and away from any liquids and out of direct sunlight.

The probe should not be submerged in any liquids.

If the thermometer is used according to the instructions, periodic re-adjustment is not required.

CHANGING THE BATTERY

Keep the battery away from children.

This device is supplied with one lithium cell battery (CR2032).

1. Unscrew battery cover.

2. Flip the battery out with a small screw driver.

3. Insert the new battery under the metal hook on the left side and press the right side of the

battery down ﬁrmly. See diagram 5.

4. Replace the battery cover.

The positive (+) side up and the negative (-) side pointed down.

SPECIFICATIONS

Temperature measurement range: 34-42.2°C (93.2-108°F)

Operating temperature range: 10-40°C (50-104°F), RH

85%

Storage temperature range: -20-+50°C, RH

≤85%

Transportation temperature: < than 70°C, RH≤95%,

Atmospheric pressure: 800~1013 hPa

Enclosure Rating: IP22

Dimensions: 149.1 x 42.5 x 54.9 mm

Weight: 79.7 grams including battery

Battery life: around 3,000 readings. Enable normal use: 1 year

Expected Service Life: 4 years

Complies with ASTM E1965-98, EN12470-5:2003 Clinical thermometers-Part 5: Performance of infra-red

ear thermometers (with maximum device), IEC/EN60601-1-2(EMC),IEC/EN60601-1(Safety) standards.

Accuracy: +/-0.2 °C (0.4 °F) in a temperature range of 35.5-42°C (95.9-107.6°F). Accuracy of +/-0.3 °C

(0.5 °F) for other temperature ranges.

This thermometer converts the ear temperature to display its “oral equivalent.” (according to the result

of the clinical evaluation)

INSTRUCTIONS FOR USE

Before ﬁrst use, pull to remove the tab from the battery cover.

INSTALLING THE HYGIENE COVER

WARNING: Choking from swallowing probe covers and connection ring by children or pets is possible,

please keep the probe covers and connection ring at places where children and pets can’t reach.

1. Gently twist the probe cap to remove. Always use a new and undamaged hygiene cover before

each reading. Ensure the ear canal is clean.

2. Place a new hygiene cover into the connection ring. See diagram 1.

3. Insert the thermometer probe into the centre of the hygiene cover and connection ring.

See diagram 2.

4. Push until it is secure. If the hygiene cover did not connect ﬁrmly, this icon will be ﬂashing

on the LCD screen. Remove the hygiene cover and re-install.

Correct installation of the hygiene cover ensures accurate readings.

5. Press ‘On/Mem’ button. The thermometer is ready for use when the ear icon stops ﬂashing

and two short beeps have sounded.

6. Gently pull the baby’s ear back, straightening the ear canal. Position the probe snugly into the

ear canal, ensuring an accurate reading. See diagram 3 and 4.

7. To measure the ear temperature, press the ‘Scan’ button until there is a long beep.

LCD

ON/MEMORY

BUTTON

FRONT COVER

BATTERY COVER

SCAN

BUTTON

REAR COVER

WORLDWIDE

SMALLEST PROBE

DIAMETER

=5.9MM

HYGIENE

COVER

DETECTOR

HYGIENE COVER

PROBE

LENS

On/Mem

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Tommee Tippee Digital Ear thermometer Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info