Bedienungsanleitung Toolland DT 20005 (Seite 12 von 16) (Deutsch, Englisch, Holländisch, Französisch)

771265

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

DT 20005 English

www.toolland.eu 12

PRESSURE SPRAYER

DT 20005

WARNING

For your own safety, read this manual

carefully before using this sprayer.

SAFETY INSTRUCTIONS

When using the appliance always observe the

safety instructions.

ASSEMBLY

 Fit the lance assembly to the sprayer by

means of the flexible hose.

 Remove the nut fitted to the lance.

 Insert hose through nut.

 Push the hose fitting fully onto the lance

connector.

 Screw nut tightly onto lance.

 Attach the other end of the hose to the

container using the above method.

 Ensure that the hose is fully pushed on

and that the nut is screwed down tight.

 Fit the carrying strap by threading the

expandable ring through the hole in the

lug moulded into the container base.

 Fit the other end of the strap through the

slot in the top lug and thread through the

metal buckle and adjust length to suit.

OPERATING INSTRUCTIONS

 Ensure that the hose is securely attached

to the sprayer and the lance and the

locking nut are tight.

 Check that the liquid which you intend to

use is suitable (see the spraying chemical

section).

 Fill the container to the desired level

taking care not to exceed the maximum

fill mark.

 Screw the pump firmly home to ensure

an airtight seal.

 Operate the pressure release valve

manually by pulling the blue knob

upwards to ensure it is functioning

correctly.

 Release the pump handle by pressing

down and turning anti-clockwise.

 Pump to pressurize the container.

 When the correct operating pressure has

been reached, the pressure release valve

will vent to discharge excess air.

 The container is adequately pressurized

and does not require further pumping.

Trigger Operation

 The trigger mechanism has been

designed to allow for two modes of

operation, either intermittent or

continuous.

Intermittent

 Depress trigger to operate and release it

to stop spraying.

Continuous

 While depressing trigger push forward

with the thumb to hold in the lock on

position.

 The sprayer will now continue to operate

without any further finger pressure, so

preventing fatigue.

 To turn off the sprayer pull back the level

and release.

 Aim the spray nozzle towards a test area,

squeeze the trigger on the lance and

adjust the nozzle to the desired degree of

fineness by twisting the nozzle from mist

through coarse spray to jet.

 Do not undo the nozzle too far or leakage

will occur from the back of the nozzle.

 If the nozzle continues to spray or drip

after the trigger has been released, it is

because there is air in the discharge

system (lance, handle trigger or hose).

 Purge the system by turning the nozzle to

jet and operating the trigger on the lance

on and off in short bursts until the liquid

shuts off cleanly.

 Collect any chemicals in a separate

container and use later.

 To keep spraying a few pumps at

infrequent interval are all that is required.

 After use and before storage release the

pressure from the container by pulling

the blue knob of the pressure release

valve upwards.

 If the sprayer has been used with

chemicals, discard safely any unused

solution after use.

 Add a little detergent and some warm

water (not hot) to the sprayer.

 Re-assemble the sprayer and spray some

of the contents through.

 Repeat with the clean, cold water.

 Check that the nozzle assembly is free

from sediment.

 If necessary repeat the process until the

sprayer is clean.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Toolland DT 20005 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info