6
ASSEMBLY
UNPACKING THE UNIT
1. Using a razor knife (Box Cutter) cut the outside, bottom, edge of box along the dotted
Line. Lift Box over the unit and unpack.
2. Carefully remove all parts from carton and inspect for any damage or missing parts. If
damaged parts are found, or parts are missing, contact your dealer immediately.
3. Locate the hardware package. The hardware is separated into steps. Remove the tools
first. Remove the hardware for each step as needed to avoid confusion.
ASSEMBLY INSTRUCTIONS
1 MAST ASSEMBLY
1. Locate the Console Mast (9) and Console Mast Cover (54) and slide the Cover onto the
Mast as far as it will go. Make sure the Console Mast Cover (54) is facing the correct way.
2. At the top opening of the Main Frame (1) of the elliptical is a Computer Cable (33).
Unravel and straighten out the Computer Cable (33) and feed it into the bottom of the
Console Mast tube (9) and out of the top opening.
3. Install the Console Mast (9) into the receiving bracket in the top of the Main Frame (1).
Put the 6pcs of 5/16" × 3/4"_ Hex Head Bolts (76) and 4pcs of Ø5/16" × Ø23 × 1.5T_Flat
Washers (103), 2pcs Ø8 × 23 × 1.5T_Curved Washers (112). Install, and hand tighten by
using the 12.14m/m Wrench (118).
NOTE: There is a electrical wire running through the Console Mast Tube (9). Be careful
not to damage or pinch this Computer Cable (33) during this procedure.
4. Connect the Front Stabilizer Bar (2) with the main frame at front joining plate by using
12/14 mm Wrench (118) to tighten 2pcs of 3/8" × 3-3/4"_Hex Head Bolt (78) , 2pcs of
Ø10 × 2T_Split Washers (114) and 2pcs of Ø3/8" × 23 × 2.0T_Curved Washer (113).
5. Place Console Assembly (32) on Console Mast , the Computer Cable (33) and
Handpulse W/Cable Assembly (37) and Handpulse W/Cable Assembly(Red)(37) plug
into the console (the same color to same color). Place console on the fixed tablets of
Console Mast ; then screw up with 4 pcs M5 × 10m/m_Phillips Head Screw (83) by
Phillips Head Screw Driver (120)(Note : Make sure the wires inserted into the riser . Do
not press the wire)
