462213
27
Zoom out
Zoom in
Vorherige Seite
1/46
Nächste Seite
4.2. REAR VIEW
1. Connection adaptor
2. Connection telephone line
5. GENERAL
With cordless telephones, radio connection replaces the cord connecting the handset
to the base unit of traditional telephones. This allows you to make and receive calls
even when you are away from the base unit. Thanks to this radio connection, your
mobility increases.
The Butler 200 has a working range of 300 m (range is reduced to 50 m inside
buildings). This working range is however strongly reduced if there are several obsta-
cles between the base and the handset. If you have gone too far away from the base,
you will hear a warning signal. Go back in the range within 10 seconds, otherwise the
connection will be broken. When the radio connection between the handset and the
base station is not possible, you will hear an intermittent tone. Move closer to the
base station so that the radio connection can be established.
6. INSTALLATION
1. Connect the telephone cord to the left socket on the rear of the base (rear of base
facing you) and plug the other end into the line wall socket.
2. Connect the power cable plug to the power socket on the right side of the rear of
the base (rear of base facing you) and plug the adaptor into a power socket.
7. BATTERY
Open the cover of the battery compartment on the backside of the handset. Connect
the battery to the connector in the battery compartment of the handset and close the
battery compartment again afterwards.
The battery of the handset needs to be charged before telephone calls can be made.
In order to have a fluent use of your cordless telephone, we would like to advise you
to proceed as follows:
To charge a new battery (speed charge procedure):
- Place the handset in the connected base station.
- Press and hold the paging button on the base station during 5 seconds until you
hear a beep. To make sure that the beep is audible, set the ring volume switch of
the base station in the maximum position.
- The battery is now charged at a high speed.
- After approximately 6 hours the battery indicator on the base station will blink
and the handset is fully charged.
To charge the battery after normal use:
The charging time of the battery depends on the number of calls made, which are
registered by the unit.
- Place the handset in the connected base station.
- When the battery indicator on the base station blinks, the handset is fully charged
(the charging time of an empty battery= 11 hours).
Do not put the handset back in the base station, every time the phone has been used.
Put the handset only on the base when it is indicated that the battery is almost empty.
It is better for the battery to be sufficiently discharged before being charged again.
You will hear an intermittent beep and the low battery indicator on the display of the
handset will blink.
A fully charged battery allows a talk time of 5 hours. In standby mode the battery has
to be recharged after approximately 50 hours .
R e m a r k s :
· The charger contacts of the handset should not come into contact with metal since
this could cause a short-circuit and damage the battery irreparably.
· The charger contacts of the battery on the base station and on the handset should
be cleaned with a soft cloth once a month.
8
9
27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Topcom Butler 200 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info