Bedienungsanleitung Topcom Butler 2505C (Seite 19 von 96) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

462214

Zoom out

Zoom in

Vorherige Seite

1/96

Nächste Seite

Topcom Butler 2505/2510 19

ENGLISH

8. TROUBLE SHOOTING

9. GUARANTEE

•This equipment comes with a 24-month warranty. The warranty will be honoured on presentation of the original bill

or receipt, provided the date of purchase and the unit type are indicated.

•During the time of the warranty Topcom will repair free of charge any defects caused by material or manufacturing

faults. Topcom will at its own discretion fulfil its warranty obligations by either repairing or exchanging the faulty

equipment.

•Any warranty claims will be invalidated as a result of intervention by the buyer or unqualified third parties.

•Damage caused by inexpert treatment or operation, and damage resulting from the use of non-original parts or

accessories not recommended by Topcom is not covered by the warranty.

•The warranty does not cover damage caused by outside factors, such as lightning, water and fire, nor does it apply

if the unit numbers on the equipment have been changed, removed or rendered illegible.

Note: Please do not forget to enclose your receipt if you return the equipment.

10. TECHNICAL CHARACTERISTICS

• Standard: DECT (Digital Enhanced Cordless Telecommunications)

GAP (Generic Access Profile)

• Frequency range: 1880 MHZ to 1900 MHz

•Number of channels: 120 duplex channels

•Modulation: GFSK

•Speech coding: 32 kbit/s

•Emission power: 10 mW (average power per channel)

•Range: 300 m in open space /50 m maximum inhouse

•Base power supply: 220 V / 50 Hz for the base

•Handset Batteries: 2 rechargeable batteries AAA, NiMh 550mAh

•Handset autonomy: 250 hours in standby

•Talk time: 15 hours

•Charging time: 6-8 hours

•Normal conditions of use: +5 °C to +45 °C

•Dialling mode: Pulse / Tone

•Flash time 100 or 250 ms

Symptom Possible cause Solution

No display Batteries uncharged Check the position of the batteries

Recharge the batteries

Handset turned OFF Turn ON the handset

No tone Telephone cord badly connected Check the telephone cord connection

The line is occupied by another handset Wait until the other handset hangs up

The icon ﬂashes

Handset out of range Bring the handset closer to the base

The base has no power supply Check the mains connection to the base

The handset is not registered on the

base

Base or handset do not ring The ringing volume is zero or low Adjust the ringing volume

Tone is good, but there is no

communication

The dialling mode is wrong Adjust the dialling mode (pulse/tone)

Not possible to transfer a call on PABX The FLASH time is too short Set the unit to Long Flash time

Telephone does not react to pressing the

keys

Manipulation error Remove the batteries and put them back

in place

B2505_eur.book Page 19 Tuesday, December 31, 2002 11:49 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Topcom Butler 2505C Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info