Bedienungsanleitung Torqeedo Cruise 6.0 FP TorqLink (Seite 76 von 92) (Deutsch, Englisch)

807536

Zoom out

Zoom in

Vorherige Seite

1/92

Nächste Seite

DE EN

8.2.4 Switching on systems with additional on/off switch for Power

24-3500 batteries

Switch on

1. Set the battery main switch to the ON position.

2. Press the additional on/off switch to switch on the batteries.

3. Depending on the conguration, press the “ON/OFF” button or operate the

key switch to switch on the system.

Switching the system off

1. Depending on the conguration, press the “ON/OFF” button or operate the

key switch to switch off the system.

»The system shuts down, the battery remains switched on.

2. Set the battery main switch to the off position.

»A small self-discharge takes place.

Switching the system and battery off

1. Depending on the conguration, press the “ON/OFF” button or operate the

key switch to switch off the system.

»The system shuts down, the battery remains switched on.

2. Set the battery main switch to the off position.

3. Press the additional on/off switch for approx. 5 seconds to switch off the

battery.

»The battery is switched off, only a very small self-discharge takes place.

TIP!

• Switch off the system if you want to, for example, take a break from driving

or stop for a swim.

• Switch off the system and the battery if you are not going to use or store

the system for a long time.

• Leave the battery switched on when you want to charge it.

NOTE! To protect the battery from deep discharging, the system switches off

automatically after 1 hour and the battery after 48 hours if it is not used.

8.2.5 Driving

1. Switch on the Torqeedo system.

2. Set the accelerator lever to the neutral position.

3. Place the emergency stop magnetic chip or connect the kill switch line to

the switch, make sure the emergency stop magnetic chip or kills witch cord

is connected to the skipper.

4. Turn the accelerator lever in the appropriate direction.

8.2.6 Multifunction display

The accelerator lever is equipped with an internal or external display. It shows all

the important data about your trip.

You can adjust the units according to your needs, see the operating manual for

the respective accelerator lever.

NOTE! Depending on the conguration and the throttle used, the multifunction

displays differ. The corresponding information can be found in the operating

manual for the respective accelerator lever.

Multifunction display

The multifunction display shows you the following data:

Battery charge state in percent

Remaining range at current speed

Speed over ground

Current power consumption in watts

8.2.7 Ending the trip

1. Set the accelerator lever to the neutral position.

2. Remove the emergency stop magnetic chip or the kill switch cord.

3. Switch off the system.

8.3 Hydrogeneration

NOTE! Torqeedo recommends only using hydrogeneration when the battery

charge state is below 95 %.

NOTE: If you use external batteries, measures may be required to prevent over-

charging, depending on the type of battery used. Clarify any necessary measures

with the battery manufacturer.

No further measures are required when using Torqeedo batteries.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Torqeedo Cruise 6.0 FP TorqLink Seite 76

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Torqeedo Cruise 6.0 FP TorqLink

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info