Bedienungsanleitung Torqeedo Deep Blue (Seite 110 von 132) (Deutsch, Englisch)

807533

110

Zoom out

Zoom in

Vorherige Seite

1/132

Nächste Seite

Operation

DE EN

page 110 / 132

6.6 Charging the high-voltage batteries

DANGER!

Danger of fire and burns from overheating or from hot component sur-

faces!

Fire and hot surfaces can result in death or severe physical injuries.

■Do not store flammable objects in the vicinity of the high-voltage equip-

ment.

■Use only charging cables which are suitable for outdoor use.

■Always unroll the cables completely.

■If the DEEP BLUE system becomes very hot or you see steam or smoke,

switch the system off immediately.

■During or immediately after a trip, do not touch any of the motor or battery

components.

■Prevent strong mechanical forces from working on the batteries and cables

of the DEEP BLUE system.

Prerequisites:

■The fuse for the Emergency Stop Switch must not be removed.

■The Emergency kill switch must not be depressed.

1. To start the charging process, insert the charger plug into the provided socket

ashore.

The charging process starts automatically.

If the system is switched on, then the displays switch on automatically. If the

system is switched off, only the display for the accelerator lever is switched

on.

As soon as AC voltage is detected at the plug, an icon is displayed on the

Drive screen.

An arrow and the combined charging power of all charger units are displayed

on the Energy Flow screen.

A plug symbol and the charging power are displayed on the accelerator lever

display.

2. To end the charging process, pull the charger plug out of the socket.

ADVICE

Although the high-voltage batteries of the DEEP BLUE system are protected

from deep discharging, a certain self-discharge is unavoidable.

In order to prevent damage to the high-voltage batteries, comply with the fol-

lowing instructions:

■Top-up the charge of the high-voltage batteries after every trip. If the high-

voltage batteries are discharged to below 20 %, then they must be recharged

within 48 hours.

■During extended storage, check the state of charge of the

high-voltage batteries once per month, by reading the state of charge from

the main screen (see "Fig. 75: Drive screen", page 92). The value must be

greater than 20 %.

■Only charge the high-voltage batteries at the permitted ambient tempera-

tures, see Chapter 3, "Technical data", section High-voltage battery.

If the sockets available for charging cannot provide the power required by the

charger unit, then under "Settings | Charger", the maximum current per charger

unit can be set using a slider, until problem-free charging is achieved.

This extends the charging time required.

If the high-voltage batteries or the charger unit heat up significantly during the

charging process (e.g. at very high ambient temperature), or they disrupt the supply

voltage excessively, then the charger unit reduces the charge automatically. This also

extends the charging time.

Via System Management | Components | Charger or Battery you can view de-

tailed values for the charging process.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Torqeedo Deep Blue Seite 110

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Torqeedo Deep Blue

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info