Bedienungsanleitung Toshiba 48T5435DG (Seite 15 von 56) (Englisch)

662664

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

English - 15 -

English

Initial Installation

Before switching on the TV, put your decoder and media recorder to Standby if they are connected and

ensure the aerial/cable is connected to your TV. To set up the TV, use the buttons on the remote control as

detailed on The Remote Control page.

IMPORTANT: Ensure that the aerial/cable is connected

and a Common Interface module is not inserted before

switching on the TV for the rst time installation.

1. Connect the mains plug and switch the TV on

using the button. If the TV does not switch on,

press any numbered or button on the remote

control, then the language selection menu will

be displayed. This screen will appear the rst

time that the TV is switched on and each time

the TV is reset.

2. By pressing Up or Down button, highlight the

language you want to set and press OK button.

The following screen will be displayed next:

3. By pressing Left or Right button, select the

country you want to set and press Down button

to highlight the Search Type option. Use Left or

Right to set the desired search type. Available

search types are Digital only, Analogue TV

only and Full.

4. When set, press Down button to highlight

Teletext Language. Use Left or Right button to

select desired language region. Highlight Scan

Encryted Channels and enable/disable this

option by using Left or Right buttons. Press OK

to continue.

Note: Depending on the Country selection you may be asked

to set and conrm a PIN at this point. The selected PIN cannot

be 0000. You have to enter it if you are asked to enter a PIN

for any menu operation later.

5. The following message will be displayed next on

the screen:

Select Store mode if the TV will be placed in a

store to exhibit. This option will congure your

TV’s settings for best display quality and the

supported features of the TV will be displayed on

the top of the screen as a info banner. If Store

mode is selected, a conrmation screen will be

displayed. Select YES to proceed. For home use

select Home Mode.

This option will be available in Other Settings

menu and can be turned off/on later.

6. Press OK button on the remote control to continue

and a message will be displayed asking wheter

you want to do network settings. Select Yes and

the Network Settings menu will be displayed.

Please refer to Connecting a Home Network and

Network Settings sections to congure a wired

or a wireless connection. After the settings are

completed press OK button to continue.

7. Afterwards, the following OSD will be displayed

on the screen:

8. If you select Cable option, a conrmation screen

will be displayed. If you want to search for

available networks, select YES to proceed. The

following screen will be displayed:

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Toshiba 48T5435DG Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Toshiba 48T5435DG

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info