Bedienungsanleitung Toshiba 55VX700U (Seite 77 von 100) (Englisch)

456105

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

Chapter 9: Troubleshooting

• If you cannot tune digital channels, check the antenna

configuration (- p. 28). If the problem persists, clear

all channels from the channel list and reprogram

channels into memory (- p. 28). If the problem

persists, use the Reset Factory Defaults procedure (-

p. 44). See “TV stops responding to controls” and

“O

ther problems” (- p. 76).

Closed caption problems

• If the program or video you selected is not closed-

captioned, no captions appear.

• If text is not available, a black rectangle may appear.

If this happens, turn off the closed-caption feature

(- p. 34).

• A closed-caption signal may not display correctly under

these circumstances: a) the videotape is dubbed; b) the

signal reception is weak; or c)

the signal reception is

nonstandard (- p. 34).

Rating blocking (V-Chip) problems

• If you forget your PIN code: While the PIN code entering

screen is displayed, press 4 times within 5 seconds.

The old PIN code clears (- p. 35).

• The V-Chip feature is available for the U.S. V-Chip

system only (- p. 35).

No REGZA-LINK operation

• The REGZA-LINK feature is available for Toshiba REGZA-

LINK compatible devices.

• Ensure HDMI cables with the HDMI Logo ( )

are used.

• When the connected REGZA-LINK device does not work

correctly after you changed the device’s settings, turn off

your TV and unplug the power cord, then plug and turn

on again.

• If several devices are connected, the REGZA-LINK

feature may not operate properly

• Read the instruction manual furnished with the

connected REGZA-LINK device.

HDMI problems

For HDMI cables

• Ensure HDMI cables with the HDMI Logo ( )

are used (- p. 14).

For Legacy HDMI sources

• Some legacy HDMI sources may not work properly with

the latest HDMI TV products due to new standard. Turn

off these HDMI settings (Content Type and

INSTAPORT™) (- p. 40).

Network problems

Cannot connect to the Internet

• Check the modem and its incoming cable/telephone

connections (- p. 22).

• Confirm your modem’s operation.

• Ensure your IP address is set up correctly.

No network connection

• If using a wired network connection, check to ensure the

LAN cables are connected properly (- p. 22).

• Ensure the modem and router power cords are plugged

in and the devices are operating properly.

• Ensure your IP address is set up correctly. See Section

(- “Setting up the Network”).

• Check to ensure prop

er operation of other network

connected devices.

Network Setup fails (Auto)

• Check to ensure the LAN cables are connected properly

(- p. 22).

• DHCP is not enabled on the r outer, or no router is

present. Refer to your router’s documentation for

instructions on enabling DHCP. If you do not have a

router, you must manually set up

the IP address.

• Internet service is not available. Check your cable/DSL

modem or contact your ISP for Internet service issues.

Network Setup fails (Manual)

• Ensure the TV IP address is not the same as any other

device on the network.

Example: IP address 192.168.0.100 and IP address

192.168.0.101 are different addresses on the same

network.

• Make sure the TV IP address is on the same subnet as

the networked PC.

Example of proper setup: The PC has IP address

192.168.0.100 with Subnet mask

255.255.255.0, the TV

has IP address 192.168.0.101 with Subnet mask

255.255.255.0; both are on same subnet.

Example of improper setup: The PC has IP address

192.168.1.100 with Subnet mask 255.255.255.0, the TV

has IP address 192.168.0.101 with Subnet mask

255.255.253.0; they are on different sub-nets.

Unstable network connection

• When using a wired home-network connection, unplug

the LAN cables, and then reconnect them.

• When using a wireless home-network connection:

– Remove AC power from the router and the television

for 30 seconds.

• Reconnect AC power to the router.

• Reconnect AC power to the television and p

ower it

ON. After 2 minutes, check connection stability.

–Connect with LAN cables, if possible, and check

connection stability.

– Repeat the wireless network setup procedure and

check connection stability.

The DMS name is not displayed

• The LAN cables, if used, are not connected properly (-

p. 22).

• The WLAN, if used, is not configured properly.

• The network setup on the Server is incorrect. Make sure

both the DMS and TV are using the same network type

(DHCP/manual) and have compatible network settings.

• Too many DMSs are connected. You cannot connec

more than 32 sharing devices at one time.

• The DMS is not turned ON.

• The “server” is not a DMS device.

• Check the firewall and streaming settings on the DMS.

Wireless network problems

• Check that the router/AP (Access point) power is ON.

• After starting wireless network setup, confirm that the

network is configured properly by performing the

network connection test (- p. 59).

• Check the router/AP’s connection status (- p. 58).

(continued)

VX700U_EN.pdf 77 2010/08/11 9:27:58

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Toshiba 55VX700U Seite 77

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info