Bedienungsanleitung Toshiba beamer mt 700 (Seite 31 von 36) (Englisch)

215032

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Additional information

English

About lamp

The product’s light source is a mercury lamp that lights at increased internal pressure. Be sure to fully

understand the following characteristics of the lamp and handle it with extreme care.

• The lamp may burst with a loud noise due to impact or deterioration, or fail to light at the expiration

of its life.

• How long it takes before the lamp bursts or the life expires may vary greatly by lamp. Some may

explode shortly after first use.

• Burst is likely to happen if the lamp is used after the replacement period has elapsed.

• When the lamp bursts, the broken pieces of glass may get inside the product or be released

outside from the openings for ventilation.

• When the lamp bursts, a slight amount of mercury gas enclosed in the lamp along with glass dust

may be released from the openings for ventilation.

Q Immediately replace the lamp when a sign appears on the screen.

• When the replacement time approaches, a message will appear on the screen.

• The risk of explosion will increase if the lamp is continuously used without being replaced.

• Frequently check the used hours and prepare spares when the replacement time approaches.

(Refer to “Lamp Time” on . )

Q When the lamp is broken

• If glass components, including a lamp and a lens, should break, handle the broken pieces with care

to avoid injury and contact your dealer for repair service.

• In the event of lamp burst, unplug the product from the wall outlet, leave and completely ventilate

the room. Then, thoroughly clean the area around the projector and discard any edible items

placed in that area.

• When the lamp bursts, consult a doctor if glass dust or mercury gas gets into your eyes or you

breathe it.

Replacing the lamp

CAUTION: HOT SURFACE! The lamp may be very hot after use. Before replacing the lamp,

turn off the projector, unplug the power cord, and allow the projector to cool for at least 45

minutes.

The lamp unit contains mercury. Disposal of mercury may be regulated due to environmental

considerations. Dispose of the used lamp unit by the approved method for your area. Contact your local

authorities or www.eiae.org.

A lamp is consumable supplies. If used for extended periods, images will appear dark, and the lamp

could burn out. This is characteristic of a lamp, and is not malfunction. (The lifetime of the lamp

depends on condition of use.) If this happens, replace it with a new one.

1. Turn off the power and unplug the power cord. Turn off all connected devices and disconnect all

other cables.

p. 28

WARNING

• If the projector is mounted on the ceiling, it is recommended to use your Toshiba dealership

when the lamp has to be exchanged.

• When replacing, always use lamp “TLPLMT70” (sold separately).

CAUTION

• If you have been using the projector, the lamp will be very hot, and may cause burn injuries.

Wait for the lamp to cool (for at least 45 minutes) before replacing it.

• If the lamp should break, please handle with care to avoid injury due to broken pieces and con-

tact your dealer for repair service.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Toshiba beamer mt 700 Seite 31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info