481920
97
Zoom out
Zoom in
Vorherige Seite
1/116
Nächste Seite
Before Calling Service Technician 95
Toner-related items
Original/Copy paper-related items
Phenomenon Usual cause Countermeasure
The toner lamp is lit. There is only a little toners
remaining in the toner car-
tridge.
This is not an equipment malfunction.
(There is still some toner in the toner car-
tridge. Do not replace the toner cartridge
until the toner lamp starts blinking.)
The toner cartridge is not
installed. Or it is not installed
correctly.
Install the toner cartridge correctly.
A toner cartridge not recom-
mended by TOSHIBA is
being used.
Use a TOSHIBA-recommended toner car-
tridge. If you use a toner cartridge other
than the one we recommend and you feel
annoyed by this lighting lamp, contact
your service representative.
P.11 “Recommended toner cartridges”
The toner lamp is blinking. The toner in the toner
cartridge has run out.
Replace the toner cartridge with a new
one.
The toner lamp does not light
even when the toner has
almost run out.
The toner-remaining check
function has been disabled
since the purchase of the
equipment.
Contact your service representative.
The equipment does not
become ready for copying
after the toner cartridge is
inserted.
The toner cartridge inserted
is not usable for this equip-
ment.
Check the product name of the toner car-
tridge. If you can see “T-1640”, this car-
tridge is usable.
Phenomenon Usual cause Countermeasure
An original jams. An original not acceptable for
the equipment is being used.
Check if the original is acceptable for the
equipment.
P.45 “Precautions for Automatic Docu-
ment Feeder (optional)”
Copy paper jams. Copy paper not acceptable
for the equipment is being
used.
Check if the copy paper is acceptable for
the equipment.
P.32 “Paper types not acceptable”
The size of the copy paper in
the drawer or on the bypass
tray is not registered prop-
erly in the equipment.
Register the size of the placed copy paper
properly.
P.37 “Preparation 3 - Registering Size
of Paper Placed”
P.51 “Preparation - Registering paper
size placed on bypass tray”
Jammed paper is located in
a place you cannot see eas-
ily.
Use the paper jam position lamp to
recheck the position where the paper jam
has occurred.
P.81 “Paper Jams”
There is no gap between the
side guides and paper in the
drawer. Or the gap is too
wide.
Adjust the gap between the side guides
and the paper properly.
P.33 “Placing paper in drawers”
Multiple feeding occurs. Paper is clinging to each
other.
Fan the paper well and place it again.
97

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

toshiba-e-studio-166

Suche zurücksetzen

  • wie kann ich die Anzahl der Gesamten kopien abrufen Eingereicht am 27-6-2023 09:08

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Toshiba e-STUDIO 166 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Toshiba e-STUDIO 166

Toshiba e-STUDIO 166 Bedienungsanleitung - Holländisch - 124 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info