681703
19
Zoom out
Zoom in
Vorherige Seite
1/84
Nächste Seite
1
19
Turning ON/OFF
Saving energy when not in use – energy saving modes –
The following modes are available; Automatic Energy Save mode, Sleep mode, and Super Sleep mode.
The table below shows the procedures to switch modes manually and conditions under which it enters
into or recovers from each mode.
Energy saving
modes
Procedure to switch
modes
Conditions to enter
the mode Status of equipment Conditions to recover
from the mode
Automatic
Energy Save
mode
When a specified
period of time *1 has
passed since the last
use of the equipment.
A message is displayed
to indicate the energy
saving status.
When you press the
[ENERGY SAVER]
button, or when print
data or fax data are
received.
Sleep mode
When you press the
[ENERGY SAVER]
button*2 or when a
specified period of
time *3 has passed.
When a particular
option *4 is installed or
when a particular
protocol *5 is enabled.
The touch panel
display turns o and
the [ENERGY SAVER]
button turns green.
Same as the Automatic
Energy Save mode.
Super Sleep
mode
When you press the
[ENERGY SAVER]
button*2 or when a
specified period of
time *3 *6 has passed.
When a particular
option *4 is not
installed and also a
particular protocol *5 is
disabled.
The touch panel
display turns o and
the [ENERGY SAVER]
button turns green.
When you press the
[ENERGY SAVER]
button, when print or
fax data are received
through a wired LAN,
or when the time set
for Scheduled Print
has come.
*1 The default value is 1 minute.
*2 The [ENERGY SAVER] button on the control panel.
*3 The default value is 1 minute .
*4 The Wireless LAN/Bluetooth Module.
*5 Any of IPX, AppleTalk and other protocols. When the IPsec function is enabled or the Ethernet speed is set to [AUTO
(-1000MB)] or [1000BASE FULL], the equipment enters Sleep mode. For details, see the following guide:
& TopAccess Guide (PDF) : “Chapter 8: [Administration] Tab Page” - “[Setup] Item List”
*6 Depending on the network environment, the time for switching to Super Sleep mode may take more than 10 minutes even if
it is set to 10 minutes or less.
To change the time for entering each mode, see the following guide:
& MFP Management Guide (PDF) : “Chapter 2: SETTING ITEMS (ADMIN)” - “GENERAL
For the European version
Contact your service representative to change the default settings.
When the set time for switching to Automatic Energy Save mode is the same as Sleep mode or Super
Sleep mode, the equipment enters into Sleep mode or Super Sleep mode.
If an original is placed on the original glass during energy saving mode, the size is not detected even when the
equipment recovers from this mode. Aer pressing the [START] button or the [POWER] button to recover from
the mode, place it on the glass again.
19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Toshiba e-STUDIO 5005ac wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Toshiba e-STUDIO 5005ac

Toshiba e-STUDIO 5005ac Bedienungsanleitung - Deutsch - 80 seiten

Toshiba e-STUDIO 5005ac Bedienungsanleitung - Deutsch - 428 seiten

Toshiba e-STUDIO 5005ac Bedienungsanleitung - Holländisch - 184 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info