43
Multifunctional Settings (continued)
Multifunctional Settings (continued)
NETWORK Menu
This projector provides the NETWORK function. If you use this
function, please set up the projector according to the Network
environment in which you use it.
memo If DHCP function on your Network is activated, the following
operation is not normally required, because DHCP function on this projector
is active as initial settings. Please see the section “Network Setting Up”.
Item Description
SETUP
Press the (or the ENTER) button, then the IP
ADDRESS menu as right comes up.
memo This menu will be shown only when the DHCP
is disabled at the NETWORK menu.
The IP Address is identification number of the projector on the Network.
1. Set the IP Address using the / buttons.
memo The same IP Address with other units cannot be used.
Press the (or the ENTER) button at the IP
ADDRESS menu, then the SUBNET MASK menu
comes up. The SUBNET MASK is an address of the
Network.
2. Set the address of the Network to be used.
Press the (or the ENTER) button at the SUBNET
MASK menu, then the DEFAULT GATEWAY menu
comes up. The DEFAULT GATEWAY is the main
device to access outside of the Network.
3. Set the address of the device as gateway to an outer Network.
DHCP
Select the TURN ON or the TURN OFF using the /
buttons. :
TURN ON TURN OFF
If your Network doesn’t support the DHCP function, select the TURN OFF.
INFORMATION
Pressing the (or the ENTER) button displays the
INFORMATION menu.
The menu shows the information about the current
Network setting as illustrated right.
RESET
Select the EXECUTE using the button to reset the NETWORK menu items. :
EXECUTE CANCEL
All items on the NETWORK menu are returned to the initial setting.
192 . 168 . 1 . 24
255 . 255 . 255 . 1
255 . 255 . 255 . 0
