Bedienungsanleitung Toshiba lcd data projector tlp x2500a (Seite 26 von 31) (Englisch)

215050

Zoom out

Zoom in

Vorherige Seite

1/31

Nächste Seite

Maintenance

Mount the new lamp.

Align the orientation, press down the new lamp

until the bottom is reached, and lock in place using

the three lamp locking screws.

Replace the lamp cover.

Align the cover, and press it in, then tighten the

screws loosened in step

until the lamp cover is

no longer loose.

Reset the lamp time.

See the lamp’s manual for instructions on resetting

the lamp time.

Notes and Precautions

• The [Lamp time] item in the Status display menu indicates the time of lamp use (as a

rough guide)

p.44

• Please replace the lamp after 2000 hours of use with [Lamp power] in the Default

setting 1 menu set to [Standard], and 3000 hours of use with [Lamp power] in the

Default setting 1 menu set to [Low].

p.42

• There are cases that the lamp can not work before the above mentioned period expires

or before the replacement message is displayed.

• Attach the lamp cover correctly so that it is not loose. If it is not attached correctly, the

projector may fail to be powered on or the lamp may fail to come on.

• Always replace the lamp with a new one.

• The lamp is made out of glass. Do not touch the glass surface with your bare hands,

bang it, or scratch it. (Dirt, jolts, scratches and the like could break the lamp.)

Used Lamps

This projector’s lamps contain trace amounts of environmentally harmful inorganic

mercury. Be careful not to break used lamps, and dispose of them in accordance with

local regulations.

Unplug power cord.

Wait until lamp is sufficiently cooled.

Wait for at least 1 hour.

Remove the lamp cover.

Loosen the two screws, raise the lamp cover

with your fingers as shown to remove the lamp

cover. Use care to avoid any damage to nails

and/or tip of your finger(s). If you have any

difficulty in removal, you can use a screwdriver

or any other smaller tool for your convenience.

Pull out the lamp.

Loosen the three lamp locking screws, pull up the

handle, and remove the lamp.

Lamp cover

A lamp is consumable supplies. If used for extended periods, images will appear dark, and

the lamp could burn out. This is characteristic of a lamp, and is not malfunction. (The lifetime

of the lamp depends on condition of use.) If this happens, replace it with a new one

WARNING

•

If the projector is mounted on the ceiling, it is recommended to use your Toshiba dealer-

ship when the lamp has to be exchanged.

Uncovering the lamp while the projector is mounted on a ceiling may lead to a danger

of damage from falling pieces of glass if the lamp is broken. Besides, working at high

elevations can also be hazardous. Do not attempt to replace the lamp by yourself.

• When replacement is required, be sure to use TLPLW11 (sold separately).

CAUTION

• If you have been using the projector, the lamp will be very hot, and may cause burn

injuries. Wait for the lamp to cool (for longer than 1 hour) before replacing it.

• If the lamp should break, please handle with care to avoid injury due to broken pieces

(

p.49

) and contact your dealer for repair service.

Lamp replacement

• The lamp replacement message of this projector displays an appropriate period

according to the use period for [Standard] / [Low] of the [Lamp power] respectively.

• When the replacement time approaches, the message of “The lamp life is ending.

Please change the lamp.” and the icon

are displayed every time the power is

turned on. This display disappears when you press the

button.

About lamp replacement messages

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Toshiba lcd data projector tlp x2500a Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info