Bedienungsanleitung Toshiba RAS-10YK-HX (Seite 33 von 59) (Englisch)

497495

Zoom out

Zoom in

Vorherige Seite

1/59

Nächste Seite

– 33 –

9. TROUBLESHOOTING CHART

TROUBLESHOOTING PROCEDURES :

• Following details of “What to be pre-checked first”, make sure of the basic items.

• When there is no trouble corresponding to above, check in detail the faulty parts following “How to judge

faulty parts by symptoms” later.

9-1. What to be Prechecked First

9-1-1. Power Supply Voltage

The line voltage must be AC 220–240V (220V for RAS-07YKX-T, RAS-10YKX-T).

If the line voltage is not within this range, this air conditioner may not work normally.

9-1-2. Incorrect Cable Connection between Indoor and Outdoor Units

The indoor unit is connected to the outdoor unit with 3 cables. Make certain that the indoor and outdoor units

have been connected properly, with terminals assigned the same numbers wired to each other. If the connectors

are not connected as specified, the outdoor unit will not operate normally.

9-1-3. Misleading but Good Operations (Program Controlled Operation)

The microcomputer performs the operations listed in Table 9-1-1 to control the air conditioner. If a claim is made

on the operation, check whether it corresponds to the contents in the Table 9-1-1. If it does, it is an indispensable

operation for the control and maintenance of the air conditioner: it is not a failure of the unit.

Table 9-1-1

No. Operation of air conditioner Description

When the power plug or the power

cord of the indoor unit is inserted,

the OPERATION lamp on the

setting indication part blinks.

The OPERATION lamp blinks, indicating that power is turned on.

If this happens, push the START/STOP button once to cause the lamp to stop

blinking. A power outage also causes the lamp to blink.

Fan speed remains unchanged in

the dry mode.

Fan speed is automatically controlled in the dry mode.

The compressor will not switch on

or off even when the thermo. control

is operated in the dry operation.

In the dry mode, the compressor goes on and off at regular intervals,

independent of the thermo. control.

Compressor does not work though

room temperature is in the range of

turning the compressor on.

Compressor does not work while the compressor restart delay (3-min.) timer

is active. The same is true after power is turned on, as the time is still active.

During automatic operation, the

operation mode changes.

After selection of the cooling and dry operation, the operation mode is

selected again when the compressor off mode continues for 15 min.

according to the room temperature. And after selection of the dry operation,

the condition of the room temperature which is Room temp. >Set temp.+1

and which is Room temp.<Set temp.–4 continues for 15 min., the operation

mode is selected again.

When the power is turned on, the

operation starts automatically.

When the auto restart controlling is selected, the operation is performed

automatically in the previous operation mode after the power supply has

been turned on.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Toshiba RAS-10YK-HX Seite 33

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info