587661
11
Zoom out
Zoom in
Vorherige Seite
1/63
Nächste Seite
5 EN
ENGLISHFRANÇAISDEUTSCHITALIANOESPAÑOLǼȁȁǾȃǿȀǾPORTUGUÊS###SW######RU###
Display
All indicators, except for the clock time indicator, are displayed by pressing the button.
a Transmission mark
This transmission mark ( ) indicates when the remote control transmits signals to the indoor unit.
b Mode indicator
Indicates the current operation mode.
Heat pump models
(AUTO: Automatic control, A: Auto changeover control, : COOL, : DRY,
:HEAT)
Cooling-only models
(AUTO: Automatic control, A: Auto changeover control, : COOL, : DRY,
: FAN ONLY)
c Temperature indicator
Indicates the temperature setting (17°C to 30°C).
d PURE indicator
Shows that the electrical air purifying operation is in progress.
e FAN speed indicator
Indicates the selected fan speed. AUTO or one of five fan speed levels (LOW ,
LOW+ , MED , MED+ , HIGH ) can be shown.
Indicates AUTO when the operating mode is either AUTO or : DRY.
f TIMER and clock time indicator
The time setting for timer operation or the clock time is indicated.
The current time is always indicated except during TIMER operation.
g Hi POWER indicator
Indicates when Hi POWER operation starts.
Press the Hi POWER button to start and press it again to stop operation.
h (MEMORY) indicator
Flashes for 3 seconds when the MEMO button is pressed during operation.
The mark is shown when holding down the button for more than 3 seconds
while the mark is flashing.
Press another button to turn off the mark.
i ECO indicator
Indicates when the ECO is activated.
Press the ECO button to start and press it again to stop operation.
j A. B change indicator remote control
When the remote control switching function is set, “B” appears in the remote
control display. (When the remote control setting is “A”, there is no indication at this position.)
Remote control switching function
Loading the remote control batteries
a Remove the cover, and insert the batteries.
b Press the RESET button.
The clock time indicator flashes. Adjust the clock. Reattach the
cover.
NAMES AND FUNCTIONS OF INDICATORS ON REMOTE
CONTROL
If two indoor units are installed in the same room or adjoining rooms, both units may start and stop at the same time when
the remote control is operated. This can be prevented by setting the switching function so that each indoor unit is operated
only by the corresponding remote control.
To use the remote control switching function, contact the air conditioner dealer or the installation company.
PREPARATION AND CHECK BEFORE USE
f
e
gi
c
ab
h
jd
In the illustration, all indicators are shown
for purposes of explanation. During
operation, only the relevant indicators are
shown on the remote control.
CLOCK
CHECK
RESET
CLR
SET
SWING
FIX
FAN
ON
OFF
b
HiPOWER
ECO
MEMO
SLEEP
1
.
3
.
5
.
9H
11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Toshiba RAS-M14GAV wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info