587661
22
Zoom out
Zoom in
Vorherige Seite
1/63
Nächste Seite
16
EN
Automatic Operation
As shown in Figures 1 and 2, Automatic Operation mode selects the operation based on the room temperature data (Ta) when
operation begins.
The operation mode is selected again after the compressor has remained stopped for 15 minutes.
Hi POWER operation
When you press the Hi POWER button during cooling, heating or A operation, the air conditioner starts the following operation.
Cooling operation
The cooling operation is performed at 1°C lower than the temperature setting.
When the room temperature is higher than the temperature setting, the air flow is directed downward. The fan speed is also set to
high*. Once the room temperature is within 1°C of the temperature setting, the air flow is returned to its previous direction.
* The noise level raises, according to the fan speed.
Heating operation (heat pump models)
The heating operation is performed at 2°C higher than the temperature setting.
The air flow direction and fan speed are automatically switched according to the operating condition.
ECO operation
When you press the ECO button during cooling, heating or A operation, the air conditioner starts the following operation.
The fan speed is controlled automatically.
Cooling operation ( )
In the minimum operation zone, where the air conditioner is operated at minimum capacity, overcooling is prevented by raising the
temperature setting.
The room temperature is thus regulated between the minimum operation zone and the temperature setting.
Heating operation ( ) (heat pump models)
In the minimum operation zone, where the air conditioner is operated at minimum capacity, overheating is prevented by lowering the
temperature setting.
The room temperature is thus regulated between the temperature setting and the minimum operation zone.
HOW THE AIR CONDITIONER WORKS
Room temperature when operation begins
or when selected again
Cooling operation
Fan only operation
Heating operation
Figure 1
Room temperature when operation begins
or when selected again
Cooling operation
Fan only operation
Figure 2
Heat pump models Cooling-only models
Room temperature
Setting temperature+1
Setting temperature
Setting temperature–1
Room temperature
Setting temperature+1
Setting temperature
22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Toshiba RAS-M14GAV wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info