Bedienungsanleitung Toshiba RDXV50 (Seite 77 von 84) (Englisch)

465046

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

Introduction Connections Playback Editing OthersFunction SetupRecording VHS Functions

Basic Setup /

TV View Operation

Troubleshooting

Before requesting service for this unit, check the table below for a possible cause of the problem you are experiencing. Some

simple checks or a minor adjustment on your part may eliminate the problem and restore proper operation.

Others

Symptom Remedy

POWER

The power does not turn on. • Check that the AC power cord is connected securely.

• Batteries of the remote control are weak.

The unit turns on automatically without

any operation.

• The unit turns on automatically 2 seconds before the timer recording.

GENERAL

The unit does not function. • “ ” or error message appears if the operation is prohibited.

• Batteries of the remote control are weak or exhausted.

No picture, sound or menu appears on

the screen.

• Check if the connections are made securely and correctly.

• Check if the cables are damaged.

• Check if a correct external input channel is selected on your TV. (See page 19.)

• Check if you have completed “Channel” setting. (See pages 21-23.)

“Clock” setting and “Channel” setting

cannot be performed.

• If a recording is in progress, these operations cannot be performed.

The unit does not operate properly. • Moisture has condensed inside the unit. Remove the disc and leave the unit

turned on for about 2 hours until the moisture evaporates. (See page 3.)

The clock display does not appear on

the front panel display.

• Check that the AC power cord is connected securely.

• (In case of power failure) Check the breaker and “Clock” setting.

• When the unit is in standby mode, front panel display is off because Power

Saving mode is applied to this product.

When you forget the password for

parental lock.

• Please cancel the password and the set level. (See page 68.)

DV signal cannot be input. • Before connection, turn on the power supplies for both this unit and the DVC,

and make sure that these units have stopped.

• Only a “DVC-SD” signal can be input from the DVC to this unit. Other types of

signals are not supported.

• Do not connect any device other than the DVC. Even if a recorder or PC with

another DV terminal is connected, the DV function will not operate.

• If the DVC is not recognised after connection, turn off the power supply for the

unit and re-connect the DVC.

The DVC cannot be operated with this

unit.

• Signal input or DVC operation from this unit may be disabled depending on the

type of DVC.

• If a DVC signal cannot be input, use an external input (AV2) for analogue

connection via audio/video cables. Use Scart adaptor for connecting to AV2.

• DVC control may be disabled depending on the type of DVC, even in a mode

other than camera mode. In this case, switch to DVD control and execute the

normal recording procedure while operating the DVC.

Certain functions of the DVC cannot

operate.

• Some functions may not operate depending on the type of DVC. For example, if

the DVC does not support slow playback mode, the slow playback function is

disabled.

• With DV (AV3), the disc display menu does not appear unless disc playback is

executed.

DV audio signal cannot be switched. • For recording with the DVC, the recording audio signal can be set to 12 bits or

16 bits. However, when 16-bit recording mode is selected, audio signal cannot

be switched. To record an audio signal, set it to 12 bits.

No image from HDMI connection. • Check the HDMI connection. (Check the status of the HDMI related indications.)

• Check whether the connected monitor device or other device supports HDCP.

(This unit will not output a video signal unless the other device supports HDCP.)

• Check the setting of HDMI.

• Check whether the output format of this unit (HDMI FORMAT) matches the

supported input format of other connected device.

• If the unit is connected to the unauthorised display device with an HDMI cable,

the audio and video signals may not be output when playing back a commercial

DVD-video.

E3TK7FD_EN.book Page 77 Wednesday, February 17, 2010 8:18 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Toshiba RDXV50 Seite 77

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Toshiba RDXV50

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info