Bedienungsanleitung Toshiba TD-Z471 (Seite 16 von 76) (Englisch)

562486

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

Preparation for use

Using the wall mount or ceiling mount

Lay the screen face down

Lay the protective sheet on a table, which was wrapped around the monitor when it was packaged, beneath the screen

surface so as not to scratch the screen surface.

This device cannot be used or installed without the Tabletop Stand or other mounting accessory. Failure to follow the

correct mounting procedures can result in damage to the equipment or injury to the user or installer. Product warranty does

not cover damage caused by improper installation. Failure to follow these recommendations can void your warranty.

For installation, use M6 screws (with a loose-proof spring washer and having a length 10 mm longer than the thickness of

the mounting bracket) and tighten them securely.

Toshiba recommends using a mounting interface that complies with VESA Requirements, TUV-GS or for North America

UL1678.

42” 47”

485 485

200 200

281.45281.45

Handles

Protective Sheet

(mm)

Table

400.00

200 200

540.1 540.1

200200

312.2312.2

Handles

Protective Sheet

(mm)

Table

For preventing the monitor from falling:

• Install the monitor with metal brackets for wall or ceiling installation (commercially available) on your own

responsibility. For detailed procedures of installation, refer to the instructions of the metal brackets.

• To lessen the probability of injury and damage resulting from fall of the monitor in case of earthquake or other

disaster, be sure to consult the bracket manufacturer for installation location.

• To lessen the risk of falling of the monitor, thread commercially available rope through the handles at the right and

left of the monitor and secure the rope to the wall mount brackets or ceiling mount brackets. Use rope that can bear a

load 6 times the weight of the monitor (42” approximately 90 kg; 47” approximately 102 kg ).

• Do not sleep where the monitor may topple over or fall in case of an earthquake or other disaster.

• Use screws having enough strength to support the LCD display monitor (made of stainless steel etc.).

About the metal bracket:

• Use a VESA-compliant metal bracket.

• Before installation, make sure that the installation surface has sufﬁcient strength.

• Use a metal bracket (commercially available) that is strong enough to hold the monitor.

• Before installation, check the strength and other properties to ensure the safety.

• Do not block the heat dissipating holes in the monitor with the metal bracket. See page 15.

• For details of the mounting procedure and the safe installation procedure, see the user instructions of the metal

bracket (commercially available) to be used.

• Take measures such as using multiple metal brackets, holding the monitor at several points, and taking measures to

prevent falling or dropping in case of a problem.

Using the wall mount or ceiling mount

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Toshiba TD-Z471 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info