Bedienungsanleitung Toshiba TDP-T420 (Seite 46 von 51) (Englisch)

485562

Zoom out

Zoom in

Vorherige Seite

1/51

Nächste Seite

90 91

Maintenance

Lamp replacement (Continued)

Unplug power cord.

Wait until lamp is sufﬁ ciently cooled.

Wait for at least 1 hour.

Remove the outer lamp cover.

Loosen the 2 screws, raise the outer lamp cover

with your fingers as shown to remove the outer

lamp cover. Use care to avoid any damage to nails

and/or tip of your ﬁ nger(s). If you have any difﬁ culty

in removal, you can use a screwdriver or any other

smaller tool for your convenience.

Remove the inner lamp cover.

Remove the screw and carefully set it aside, and

take off the inner lamp cover. Be sure not to loose

the screw.

Pull out the lamp.

Loosen the 3 lamp locking screws, pull up the

handle, and press the tab to remove the lamp.

Mount the new lamp.

Align the orientation, press down the new lamp until

the bottom is reached, and lock in place using the 3

lamp locking screws.

Inner lamp cover

Ta b

Outer lamp cover

Replace the inner lamp cover.

Tighten the screw removed in step

until the inner lamp cover is no longer loose.

Replace the outer lamp cover.

Align the cover, and press it in, then tighten the screws loosened in step

until the outer

lamp cover is no longer loose. (Be sure to replace the outer lamp cover.)

Reset the lamp time.

See the lamp’s manual for instructions on resetting the lamp time.

Notes and Precautions

The [Lamp time] item in the Status display menu indicates the time of lamp use (as a

rough guide)

p.43

Please replace the lamp after 2000 hours of use with [Lamp power] in the Default

setting 2 menu set to [Standard], and 3000 hours of use with [Lamp power] in the

Default setting 2 menu set to [Low].

p.42

There are cases that the lamp can not work before the above mentioned period expires

or before the replacement message is displayed.

Attach the outer lamp cover correctly so that it is not loose. If it is not attached correctly,

the projector may fail to be powered on or the lamp may fail to come on.

Always replace the lamp with a new one.

The lamp is made out of glass. Do not touch the glass surface with your bare hands,

bang it, or scratch it. (Dirt, jolts, scratches and the like could break the lamp.)

About lamp replacement messages

The lamp replacement message of this projector displays an appropriate

period according to the use period for [Standard] / [Low] of the [Lamp power]

respectively.

When the replacement time approaches, the message of “The lamp life is ending.

Please change the lamp.” is displayed every time the power is turned on. This

display disappears when you press the

button.

•

Used Lamps

This projector’s lamps contain trace amounts of environmentally harmful inorganic

mercury. Be careful not to break used lamps, and dispose of them in accordance with

local regulations.

•

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Toshiba TDP-T420 Seite 46

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info