Bedienungsanleitung Toshiba TDP-TW95 (Seite 41 von 46) (Englisch)

485632

Zoom out

Zoom in

Vorherige Seite

1/46

Nächste Seite

Maintenance

Pull out the lamp.

Loosen the three lamp locking screws, pull up the

handle, and remove the lamp.

Mount the new lamp.

Align the orientation, press down the new lamp

until the bottom is reached, and lock in place using

the three lamp locking screws.

Replace the lamp cover.

Align the cover, and press it in, then tighten the

screws loosened in step

until the lamp cover is

no longer loose.

Reset the lamp timer.

See the lamp’s manual for instructions on resetting

the lamp timer.

Notes and Precautions

• The Lamp time item in the Status display menu indicates the time of lamp use (as a

rough guide).

p.44

• It is recommended that the lamp be replaced after 2,000 hours of use. When [Lamp time]

reaches 2,000 hours, the

icon and a message will appear. (After 2,000 hours, they will

appear when the power is on at the first time every 100 hours.) This display disappears

when you press the

button.

• Attach the lamp cover correctly so that it is not loose. If it is not attached correctly, the

projector may fail to be powered on or the lamp may fail to come on.

• Always replace the lamp with a new one.

• The lamp is made out of glass. Do not touch the glass surface with your bare hands,

bang it, or scratch it. (Dirt, jolts, scratches and the like could break the lamp.)

Used Lamps

This projector’s lamps contain trace amounts of environmentally harmful inorganic

mercury. Be careful not to break used lamps, and dispose of them in accordance with

local regulations.

Unplug power cord.

Wait until lamp is sufficiently cooled.

Wait for at least 1 hour.

Remove the lamp cover.

Loosen the two screws, raise the lamp cover

with your fingers as shown to remove the lamp

cover. Use care to avoid any damage to nails

and/or tip of your finger(s). If you have any

difficulty in removal, you can use a screwdriver

or any other smaller tool for your convenience.

Lamp cover

A lamp is consumable supplies. If used for extended periods, images will appear dark, and

the lamp could burn out. This is characteristic of a lamp, and is not malfunction. (The lifetime

of the lamp depends on condition of use.) If this happens, replace it with a new one

WARNING

•

If the projector is mounted on the ceiling, it is recommended to use your Toshiba dealer-

ship when the lamp has to be exchanged.

Uncovering the lamp while the projector is mounted on a ceiling may lead to a danger

of damage from falling pieces of glass if the lamp is broken. Besides, working at high

elevations can also be hazardous. Do not attempt to replace the lamp by yourself.

• When replacement is required, be sure to use:

TLPLW9 for TDP-TW95 or

TLPLW10 for TDP-TW100

(sold separately).

CAUTION

•

If you have been using the projector, the lamp will be very hot, and may cause burn injuries

Wait for the lamp to cool (for longer than 1 hour) before replacing it.

•

If the lamp should break, please handle with care to avoid injury due to broken pieces and

contact your dealer for repair service.

Lamp replacement

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Toshiba TDP-TW95 Seite 41

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info