Bedienungsanleitung Toshiba TLP-T50 (Seite 5 von 20) (Englisch)

485565

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

Before Using

8 9

IMPORTANT PRECAUTIONS (Continued)

Avoid Volatile Liquid

Do not use volatile liquids, such as an insect spray, near the unit. Do not leave rubber or

plastic products touching the unit for a long time. They will leave marks on the finish.

If cleaning with a chemically saturated cloth, be sure to follow the product's precautions.

LCD Panel

The life of the LCD panel is limited. Take care over the points below so as to use the panel

for years.

• To prolong the life of this panel, never fail to turn the power off when the panel is not in use

and make sure that the lamp has gone out. The state of the lamp being extinguished helps

enhance the effect of energy saving.

• If the air filter is stained and is clogged up, the main unit inner temperature rises. As a

result, the life of the LCD is shortened and a malfunction may also occur.

Clean the air filter from time to time and replace it regularly. It is recommended that this

replacement be done at the time of replacing a lamp. (Ask a dealer where the unit was

purchased or your nearby service station about an air filter for replacement.)

In the spaces provided below, record the Model and Serial No. located at the bottom of your

LCD projector.

Model No. Serial No.

Retain this information for future reference.

POWER SUPPLY CORD SELECTION

If your line voltage is 220 to 240V, use one of the following types of cable.

Plug

configuration

Plug type

Australian

240V

10A

North American

240V

15A

Switzerland

240V

Line voltage

EURO

220 – 240V

200 – 240V

Plug

configuration

Plug type Line voltage

Use a 5A fuse which is approved by ASTA

or BSI to BSI362.

Always replace the fuse cover after

changing the fuse.

IMPORTANT PRECAUTIONS

Save Original Packing Materials

The original shipping carton and packing materials will come in handy if you ever have to

ship your LCD projector. For maximum protection, repack the set as it was originally packed

at the factory.

Moisture Condensation

Never operate this unit immediately after moving it from a cold location to a warm location.

When the unit is exposed to such a change in temperature, moisture may condense on the

crucial internal parts. To prevent the unit from possible damage, do not use the unit for at

least 2 hours when there is an extreme or sudden change in temperature.

Place and Manner of Installation

• Do not place in hot locations, such as near heating equipment. Doing so could cause

malfunction, and shorten the life of the LCD panel.

• Avoid locations with oil or cigarette smoke. Doing so will dirty the LCD panel and other

optical parts, shortening their lives, and darkening the screen.

• Do not use in angle of 20° or more degrees. Doing so could shorten the life of the lamp.

• If used at high altitudes, the unit could cease operation even if used within the rated

temperature range. This is because the thinner air at high altitudes decreases the internal

cooling efficiency. Therefore, please lower the ambient temperature if using at high altitudes.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Toshiba TLP-T50 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info