Bedienungsanleitung Toshiba TLP-T50 (Seite 16 von 20) (Englisch)

485565

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

Maintenance

■ Lens cleaning

• Clean the lens with a commercially available blower and/or

lens cleaner.

• The lens is easily scratched, so do not rub it with hard objects,

or strike it.

■ Main unit cleaning

• Clean the main unit after unplugging the power cord.

• Wipe dirt off the main unit gently with a soft cloth.

• If the soiling is severe, dip the cloth in a neutral

detergent diluted in water, wring well, and gently wipe

off the dirt, then finish up by wiping with a dry cloth.

● Replacing air intake and exhaust fans, and air filter

To maintain the performance, it is recommended that these should be replaced about

every 2 to 3 years. Consult with your dealer for details.

Lamp replacement

A lamp is consumable supplies. If used for extended periods, images will appear dark, and

the lamp could burn out. This is characteristic of a lamp, and is not malfunction. (The

lifetime of the lamp depends on conditions of use.) If this happens, replace it with a new

one.

CAUTION

• Request cleaning and maintenance of a ceiling-mounted unit from your projector

dealership.

• When replacing, always use lamp “TLPLV1” (sold separately).

• If you have been using the projector, the lamp will be very hot, and may cause burn

injuries.

Wait for the lamp to cool (for longer than 1 hour) before replacing it.

• If the lamp should break, please handle with care to avoid injury due to broken pieces

and contact your dealer for repair service.

Unplug power cord.

Wait until lamp is sufficiently cooled.

Wait for at least 1 hour.

Lens and main unit cleaning

The air filter prevents dust and debris from getting inside the projector. Never run the

projector with the filter removed. It is recommended that the air filter is cleaned regularly.

(A recommended measure is about once for every 50 hours of use.)

CAUTION

• Request cleaning and maintenance of a ceiling-mounted unit from your projector

dealership.

Unplug power cord.

Remove the air filter.

Pull out the air filter by taking the catch shown in the figure.

Clean the filter.

Carefully remove the dust and dirt from the air filter with a

vacuum cleaner or the like.

Replace the air filter.

Notes

• Allowing dirt and dust to build up on the air filter will worsen the air circulation inside the

projector, causing the internal temperature to rise, causing the projector to stop working

or malfunction.

• Insert the air filter all the way in. Leaving gaps will allow dust and dirt to get inside the

projector.

• If you wash the air filer with water, make sure to dry it completely before replacing it.

• If the air filter is torn, consult with your dealer about replacing it with a new one.

Continuing to use a ripped filter will allow dust and dirt to get inside the projector.

Air filter cleaning

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Toshiba TLP-T50 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info