AFTER REPLACING THE WICK, CHECK THE OPERATlON OF THE AUTOMATlC
EXTINGUISHER.
Wick height on position should be 8mm when wick adjuster knob is turned
fully cIockwise. Be sure to check.
NOTE: lf wick does not move smoothly and easily, or wick height on position
is not in the range of 7-9mm do not use heater. Disassemble and
repeat items 5 through 10.
NOTE: lf any ragged edges appear on the top of the wick, trim them with a
scissors carefully. DO NOT cut the body of the wick.
11. Replace the heater cover on the fuel tank and secure it into position with three
(3) screws.
12. Once again, check the proper operation of the automatic extinguisher.
NOTE: Before lighting a new wick for the first time, turn the wick to its
lowest position and allow the wick to saturate with kerosene for
about thirty (30) minutes.
STORAGE
At the end of each heating season, or when you do not plan to use your heater for an extended period of
time, the following procedures are recommended.
1. CLEAN WlCK AND HEATER
Follow directions in ”INSPECTlON OF THE WlCK”.
2. DRAIN FUEL TANK
After you have burned your heater dry, a small amount of kerosene will remain in the fuel tank. lt should be
removed in order to avoid contamination when the heater is refueled at a later date. To do this, remove the
fuel cap, tip the heater toward you and insert a small syringe into the bottom-most portion of the fuel tank.
Empty the tank completely before storage.
3. STORE HEATER
The original shipping carton is the best place to store your heater. If you do not have original packing
materials, cover the heater with a large plastic bag and store in a dry place.
13
