5
SET CLOCK
It is only possible to set the correct time, when the heater is
connected to the mains and not burning.
1. Use the Adjustment Keys (▼ hour / ▲ min.) to set the time.
2. To set the time, press “hour” and “min.”
set buttons. Individual motions will
increase the time by one unit; holding
continuously will raise either the “hour” or
“min.” rapidly. After approximately 10
seconds the blinking will stop and the
setting will be locked. 5 Minutes after
switching off the heater, the information on the display will disappear and the heater
will automatically switch into the stand-by position.
1. Just press the button to ignite the
heater. The botton will start blinking,
indicating that the ignition procedure has
started. This will take a short while.
2. After this time heater will automatically
ignite and Operation Lamp will cease its flashing. The Operation Lamp will remain
alight so long as heater is burning.
NOTE
:
If using your heater for the first time, or after long term storage, ignition may
not take place on the first try. Press the button again.
NOTE
:
Fuel pump may produce an audible operating noise at ignition. This is only
IGNITION
OPERATION
CAUTION
:
Always make sure that there is sufficient ventilation.
