Bedienungsanleitung Traeger BAC236 - Digitale Thermostat Kit (Seite 7 von 8) (Englisch)

798769

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

Control Shutdown cycle

The digital control for the BBQ020 comes with an automatic shut down cycle.

When finished cooking on your BBQ020 set the Dial Knob to the off position, this will

leave the Draft Induction Fan running for ten minutes to burn any excess pellets in the

fire pot. After the fan runs for ten minutes the controller will power off and the fan and it

will stop running. CAUTION! The main power switch will shut the power off to the

controller and the Dial Knob switch will cut off power to the grill components only. When

servicing the controller or any parts ensure that the power supply is disconnected to

avoid a shock hazard.

THERMOSTAT CONTROL FUNCTIONS

Adjustment of the “P”(Smoke) settings:- call customer service before adjusting.

Due to the widely varying temperature swings and operating environments experienced

by our customers, the digital controllers contain a function that will allow the grill to

better function in extreme temperature conditions for the smoke function. These

changes should only be performed when the conditions are expected to be present for

extended periods.

In order to access this functionality, locate the small hole on the face plate of the digital

controller just to the right of the red digital display. Turn the controller knob to the 225

setting. Using a very small screwdriver or other pointed object (a bent paper clip works

well), insert into the hole and use it to depress the micro switch located inside. Each

time you depress the switch, the digital readout will change from a temperature display

to a “P” setting followed by a number. The factory default setting is P-2. The setting

range available is from P-0 to P-5 (however it is not recommended that a setting above

5 ever be used). The “P” readout will change each time you depress the micro switch.

With all “P” settings, the Auger motor on time remains constant at 15 seconds while

the Auger motor time off is influenced by the “P” setting.

P-2 Setting (factory): Auger motor on time of 15 seconds, off time: 65 seconds.

P-3 Setting: Auger motor on 15 seconds, off time: 75 seconds

P-4 Setting: Auger motor on 15 seconds, off time: 85 seconds

P-5 Setting: Auger motor on 15 seconds, off time: 95 seconds

Increasing the number decreases the Smoking Temperature. Decreasing the number

increases the Smoking Temperature.

Note: The Traeger Service Department recommends a setting no higher than P-5! Also,

once

a Smoke Adjustment is made, the temperature on the digital readout should be

monitored. If the temperature is consistently below 160 degrees F while “Smoking”,

there is a risk of losing the fire in the firepot. If your fire should go out while “Smoking”,

turn the controller to the OFF POSITION. DO NOT attempt to restart the Grill until you

complete the recovery process (below). Failure to do so could result in an “over firing”

condition and can cause serious damage to your Grill.

Recovery process:

• Make sure that the Grill is cool to the touch!

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Traeger BAC236 - Digitale Thermostat Kit Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info