798771
3
Zoom out
Zoom in
Vorherige Seite
1/8
Nächste Seite
INSTALLATION INSTRUCTIONS
REMOVING THE EXISTING SMOKER CONTROL:
1) Make sure the Switch/Dial is in the OFF position. Disconnect the Power Cord from
the electrical outlet.
2) Review the Digital Control Wiring Diagram to familiarize yourself with the color coding
of the wiring connections. Disconnect the wiring from the Smoker Control by
separating the 4 Molex Connectors found on the underside of the Pellet hopper.
3) Remove the two screws securing the Smoker Control to the Pellet Hopper. Save
these screws as they will be used to mount the Digital Control later.
4) Carefully remove the Smoker Control through the opening in the front of the Pellet
Hopper. You may need to adjust the angle of the Smoker Control to allow the circuit
board to pass through the opening. Save the Smoker Control in case you should
have a problem with your Digital Control. It can be reinstalled until the problem with
the Digital Control is resolved.
INSTALLING THE RTD:
1) Open the Door and remove the Porcelain Grill and Grease Drain Pan to provide
access to the left side of the Grill.
2) Carefully cut the cable tie securing the RTD Wires to the RTD. Remove the Screw
and Lock Nut from the RTD mounting bracket if they are attached.
3) Thread the RTD Wires through the center hole of the RTD Grill Filler and then
through the small hole in the left end of the Grill. Continue to feed the RTD wires
through the Grill until the lower end of the RTD can be inserted into RTD Grill Filler.
On new Grills there will be a “Digital Thermostat RTD Mounting Hole” label pointing to
the holes in the RTD Grill Filler. Refer to the RTD Installation Diagram for additional
information.
4) Mount the RTD to the RTD Grill Filler using the 1/2” long Screw and the Lock Nut as
shown in the RTD installation Diagram. Tighten to secure the RTD.
5) Run the RTD Wires down through the space between the end of the Grill and the
Pellet Hopper. Then feed the Wires up through the opening for the Control.
3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Traeger BAC331 - Digital Thermostat Kit wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info