Bedienungsanleitung Traeger Ironwood 885 - Gen 1 (Seite 20 von 28) (Englisch)

798654

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

OPERATING TIPS (cont.)

TROUBLESHOOTING

8. GREASE MANAGEMENT:

CAUTION! Grease res are caused by not

properly maintaining the grill and failing to

clean the Traeger Grease Management System

(TGMS) on a consistent basis (see “Maintaining

Your Grill”). In the unlikely event of a grease

re while cooking, turn the grill off and keep

the door closed until the re is completely out.

Never keep the door open during a grease re.

If the re does not go out, lightly sprinkle

baking soda on the re.

CAUTION! Be careful not to burn yourself. If

this does not work, carefully remove the food

from the grill and keep the door closed until the

re is completely out. Again, be careful not to

burn yourself. When the grill is completely cool,

remove all internal components. Clean any grease

accumulation from the TGMS. Replace the grease

drip tray and grill grates, restart the grill, and

resume cooking.

Although rare, you may see an error message display on your control panel. Please refer to the following chart

for potential issues and how to resolve them:

CODE ERROR SOLUTION

LEr Low temperature This will occur if the temperature of the grill falls below 120°F for 10 minutes,

causing the grill to go into shutdown mode. To x, remove any pellets from the

repot. Turn the controller off and then on again and restart your grill. If the

problem persists, call customer service.

HEr High temperature This error will occur when the temperature in the grill reaches temperatures

above 550°F for more than 45 seconds. Let the grill cool, then turn off the

grill. Clear out any remaining pellets from the repot and restart your grill.

If the problem persists, call customer service.

Er1 Bad probe Your probe will need to be replaced.

Er2 Thermocouple

disconnected

Check the connection underneath the hopper for the thermocouple. If it is

tight, your thermocouple will need to be replaced.

Er3 Failed to ignite Check the connection of the hot rod. If the connection is good, then the hot

rod will most likely need to be replaced

Er4 Fan disconnected Check the connection of the fan. If the connection is good, then the fan will

most likely need to be replaced.

Er5 Igniter disconnected Check the connection of the hot rod. If the connection is good, then the hot

rod will most likely need to be replaced.

Er6 Auger disconnected Check the connection for the auger. If the connection is good, then auger

motor will most likely need to be replaced.

Er7 Auger jammed With the grill in Idle mode, press and hold the DOWN and IGNITE buttons at

the same time. The display will ash “Clr,” and for the next 60 seconds, the

auger will cycle between moving forwards and backwards to clear the jam.

To stop the sequence before it is complete, press and hold the DOWN and

IGNITE buttons at the same time.

3883 Ironwood_UCG updatev02.indd 20 12/19/17 2:50 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Traeger Ironwood 885 - Gen 1 Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info