Bedienungsanleitung Traeger Jr Elite 20 - TFB29LZA (Seite 8 von 23) (Englisch)

798758

Zoom out

Zoom in

Vorherige Seite

1/23

Nächste Seite

SECTION TWO: INITIAL FIRING INSTRUCTIONS

(To be used on initial firing or anytime the Grill runs out of Pellets)

In order to ensure proper operation of the Grill, you must first

allow the Auger Tube to be “charged” with Pellets.

1) Open the Door and remove the Porcelain Grills, Grease Drain Pan and Heat Baffle from

inside the Grill.

2) Make sure the Switch is in the OFF (o) position. Plug the Power Cord into an appropriate,

grounded electrical outlet.

3) Open the Pellet Hopper Lid and locate the Auger. Make sure there are no foreign objects in

the Auger. Turn the Switch ON (--) and the Temperature/dial to smoke look into the Pellet

Hopper to confirm the Auger is turning. At the same time, place your fingers over the

Firepot and feel the air movement from the Draft Inducer Fan. Look to see if the Hot Rod is

getting hot (it will start to turn red). CAUTION! Do not touch it. Turn the Temperature/dial

to SHUT DOWN CYCLE.

4) Fill the Pellet Hopper with TRAEGER BBQ PELLETS. WARNING! Use only TRAEGER

BRAND BBQ PELLETS, which are specifically made to work in our Grills. Never use

heating fuel pellets in the Grill. Turn the Temperature/Dial to HIGH. Note: During the

initial charging of the Auger, it will take time for the Pellets to travel from the Pellet Hopper

to the Firepot. When the Pellets begin to fall into the Firepot, turn the Temperature/Dial to

Shut Down Cycle.

5) Set the Temperature/Dial to SMOKE. Let the Pellets come to full flame. Once you see

flames come out of the Firepot, turn the Temperature/Dial to SHUT DOWN CYCLE, and let

the Grill cool down.

Recommendation: For ease of clean-up, line the Grease Drain Pan with heavy-duty

aluminum foil. Be sure the edges and ends of the foil are tight against the bottom of

the Grease Drain Pan. Position the Heat Baffle, The foil lined Grease Drain Pan and

Porcelain Grills in their proper locations.

6) With the Door open set the Temperature/Dial to SMOKE. In approximately 2 minutes you

will notice whitish-gray smoke coming out of the Grill as the Pellets ignite. After assuring

the Pellets have ignited, close the Door and set the Temperature/Dial to any cooking

setting desired.

7) Note: Before cooking the first batch of food in your new Grill, you will need to

season the Grill. Turn the Temperature/Dial to HIGH and run for 45 minutes at this

setting with the Door closed. This must be done before cooking any food on the

Grill.

8) The Grill should be allowed to preheat for approximately 10 minutes with the Door closed

before placing food in the grill.

ALWAYS START THE GRILL ON SMOKE SETTING

WITH THE DOOR OPEN

Once the Pellets are ignited, close the Door and

set the Temperature Dial to any cooking temperature desired.

NOTE: When operating this Grill, maintain a minimum

clearance of 12 inches from Grill to combustibles

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Traeger Jr Elite 20 - TFB29LZA Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info