Bedienungsanleitung Traeger Pro 22 - Gen 1 (Seite 23 von 32) (Englisch)

798678

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

traegergrills.com

How do I

remove the

auger if it

jams?

DANGER! Turn the switch OFF (O) and disconnect the power cord.

CAUTION! If the grill is still hot, allow it to cool thoroughly.

Remove any covers necessary to access the auger drive motor.

Remove the screw connecting the auger drive motor shaft to the auger shaft and the screw

retaining the auger bushing into the auger tube.

With a small pipe wrench or locking pliers on the auger shaft, turn the auger

counterclockwise. It will turn hard until it breaks free; then the auger will turn freely.

Remove the auger and clean all pellets, ash, or foreign objects from the auger, auger tube,

and repot. (See instructions for proper handling and disposal of ash on page 19.)

Sand the outside surfaces of the auger with medium grit sandpaper. Check the inside of the

auger tube and sand it if needed. Vacuum the sanding grit out of the auger tube and repot

when nished. Check that the auger rotates freely.

Reattach the auger shaft to the auger drive motor shaft.

Why does

my grill

re go out

on SMOKE

setting?

There may be excess ash in the repot which needs to be cleaned.

WARNING! If the re in the repot goes out

while smoking and there are sufcient pellets

in the pellet hopper, it is important to follow

these steps. Failure to do so may cause a

hazardous “over-ring” of your grill due to an

excess of unburned pellets in the repot.

DANGER! Turn the switch OFF (O) and

disconnect the power cord. Allow the grill to

cool thoroughly. Open the door and remove

all food, the porcelain-coated grill grate, the

grease drain pan, and the heat bafe.

WARNING! Remove all unburned pellets and

ash from inside and around the repot. (See

instructions for proper handling and disposal

of ash in on page 19.)

Before replacing the heat bafe, grease drain

pan, and porcelain-coated grill grate, plug

the power cord into the appropriate grounded

electrical outlet and turn the switch ON (I).

Pellets should fall into the repot and the hot

rod should begin to heat (it will start to turn

red). CAUTION! Do not touch the hot rod.

When ames start to come out of the repot,

turn the switch off (O). Let the grill cool

down. Now you’re ready to place the heat

bafe, grease drain pan, and porcelain-

coated grill grate back into the grill. With the

door open, turn the switch ON (I) and turn

the temperature dial to SMOKE. In about 2

minutes, the pellets will ignite and whitish-

gray smoke will come out of the grill. After the

pellets have ignited, close the door and turn

the temperature dial to any cooking setting

desired.

If this does not x the problem, contact

Traeger's VIP-365 Customer Service

(see page 27) for assistance.

66103_PRO15_v10.indd 23 11/12/15 11:30 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Traeger Pro 22 - Gen 1 Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Traeger Pro 22 - Gen 1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info