Bedienungsanleitung Trebs 99261 Comfortcook (Seite 35 von 54) (Deutsch, Englisch, Holländisch, Französisch)

569459

Zoom out

Zoom in

Vorherige Seite

1/54

Nächste Seite

5.2 Assembly

1. Place the base unit (8) on a flat surface, e.g. a kitchen counter, and make sure it is standing

firmly.

2. Push the collection tray (5) into the base unit and ensure that the handle end faces outwards.

3. Install the chosen attachment into the holder, depending on what you are going to use the

appliance for (see the section about the individual attachments below). Turn the holder so that

the pin on the small handle faces upwards. Place the attachment in the holder so that the small

round hole in the attachment fits over the pin on the left side of the holder.

4. Place the holder with the installed attachment onto the base unit so that the rollers rest in the

inside edge. The end with the small handle should be placed in the furthermost end of the base

unit.

5. Place the lid (6) onto the base unit whilst ensuring that the slit in the lid fits over the pin on the

holder’s small handle. Press the lid until it clicks into place. Using a finger, check whether the

holder can be moved freely back and forth.

6. Install the motor unit (9) above the lid, so that it fits down over the pin in the slit and the two

pins at the top of the lid.

7. Decide whether to use the large (7), medium (3) or small (2) feed tube, depending on the size of

the vegetables you are going to chop/ slice. Select the corresponding pusher that matches the

size of the feeder opening. See explanation in the table below.

8. The locking ring (4) fixed around the medium-sized feed tube is equipped with a tongue that acts

as an off button. The tongue should be fitted into the recess around the activation pin (10) on

the motor unit before the appliance can be started. The appliance is designed so that this part is

always used, either as a feed tube or as a part of the large pusher.

9. The appliance is now ready for use.

Feed tube

To be used with

Large feed tube (80 mm diameter)

Large pusher (= medium feed tube + small feed

tube + small feeder) (1+2+3)

Medium feed tube (60 mm diameter)

Medium pusher (= small feed tube + small

pusher (1+2)

Small feed tube (40 mm diameter)

Small pusher (1)

PLEASE NOTE

 NEVER put fingers, utensils or similar into the feeding pipe or collection tray whilst the

appliance is in use.

 NEVER use fingers, kitchen utensils or similar to push ingredients down the feed tube. Always

use the pusher.

 NEVER touch the moveable parts whilst the appliance is switched on or connected to the

mains.

5.3 The grater attachment

The grater attachment (12) is intended for grating vegetables and cheese. We recommended using

the appliance with hard chesses, such as parmesan. Soft cheeses are not very well suited for grating.

1. Install the grater attachment into the holder and install the holder onto the appliance.

2. Install the lid and motor unit onto the appliance.

3. Connect the appliance.

4. Select the feed tube that corresponds to the size of the foods to be grated.

5. Cut the cheese or vegetables into long sticks, and place the sticks in the feed tube.

6. Ensure that the tongue on the locking ring fits down into the recess around the activation

pin.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Trebs 99261 Comfortcook Seite 35

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info