Bedienungsanleitung Trek Ride plus - E-bike (Seite 20 von 40) (Englisch)

516339

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

EN-17

ENGLISH

InstruCtIons for use

• Switching lights On/Off

Press the

buttonfor2secondstoswitchOn/Offthecontroller

display light, and, if present, the front and rear lights. This switches

on the front light, the rear light, and the backlight in the display.

The lights will stay On even when you stop. Even when the battery

gauge shows ‘empty’, there is enough energy to run the lights for

about two hours. If the battery pack is fully drained, the lights will be powered by the system as it

switchestogenerativemodeautomatically.ToswitchthelightsOff,holdthebuttonfor2seconds.

• Mountain mode

The“MountainMode”allowsforlongeruphillridingbeforethemotorshowspowerreductiondueto

so-called“temperature-derating”.As“MountainMode”limitsthemaximummotortorquethemotor

willstaycoolerforalongerperiodoftime.Selectthisoptionbygoingtoassistancelevel4andthen

press-and-holdthe‘+’buttonfor2seconds.Toreturntoassistancelevel4,pressthe‘-‘buttononce.

• Removing and installing the BionX G2 controller

ToremovetheBionXG2controllerfromthebike,pressthecatchat

the back of the holder and slide the controller off towards the rear.

ToinstalltheBionXG2controllerontothehandlebar,alignthe

controller with its clamp and slide the controller forward until it

clicks.

NOTICE. To prevent loss of riding information, please make sure that the system is switched Off

before the controller is removed from the bike.

• Unintended removal of controller out of its dock

Ifthecontrollerismovedoffitsclampwhilethesystemisactive(‘On’),thesystemwillnolonger

assist, even when the controller is replaced into its clamp. Please select the correct level of

assistance again to reactivate the system.

• Using the BionX remote

MostbikeswiththeBionXG2controllerpositionedonthemiddleclampare

equipped(orcanbeequipped)withtheBionXremote.Thisdeviceismounted

either the right or left side of the handlebar and can be used to regulate the

following functions without moving your hands off the handlebar:

1. ‘+’ button Increaseassistlevel(ordecreaseregenerationlevel)

2. ‘-‘ button Decreaseassistlevel(orincreaseregenerationlevel)

3. Throttle button For Pedelecs: walkassistupto3or6km/h(pedalingnot

needed)

For fast E-bikes:assistupto25km/h(pedalingnotneeded)

• Installation of the BionX remote for non-equipped bikes

To connect the BionX remote to the system, the remote connector can be plugged into the receiver

connectorofthecontrollerdocking.Afterthat,thebrakegeneratorconnectorcanbepluggedinto

the remote connector. The red throttle button on the BionX remote is a convenient help to move

thebikewithoutpedaling(upto4km/h)walkingnexttotheE-bike.

WARNING. Beware of unintended use of the throttle button when the system is switched On.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Trek Ride plus - E-bike Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Trek Ride plus - E-bike

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info