Bedienungsanleitung Trek Ride plus - E-bike (Seite 27 von 40) (Englisch)

516339

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

EN-24

ENGLISH

4.5 Lighting

The front and rear lights, as well as the display light, are switched ‘On’ and ‘Off’ on the RIDE+ controller.

When the battery pack shows ‘empty’, there is still enough capacity left to run the lights for about

twohours.Theonboardsoftwareensuresthat-aslongasthebikeismoving-thelightscanoperate

for an indefinite period of time using the dynamo function of the motor as the power source.

WARNING. Do not ride the electric bike without the battery pack. The battery pack must be on the

bike while riding, else the bike has no lights when needed.

4.6 Charging the battery pack

WARNING. Before charging, make sure that the system is switched Off and never turn the system

On or Off during charging. This prevents unintended activation of the system. Only use the power supply

approved for use with this bike. Charging with a non-original power supply may cause the battery pack

to overheat, catch fire, or even explode. When charging, do not let the battery pack or power supply get

wet – because of risk of electrical shock.

The battery pack can both be charged in the bike or it can be removed from the bike for charging.

Li-Ionbatteriessuchasareusedintheelectricbicycle,haveno‘memory-effect’.Thismeansthat

the battery capacity is not influenced if the battery pack is recharged before it is completely empty.

You can recharge after every ride. However, you will get the most from your battery pack if, for the

first three charges, you use it until only one unit is showing in the ‘fuel gauge’ on your display.

NOTICE. When it is necessary to recharge, the battery pack will emit a ‘beep’. Charge the battery pack immediately.

Batterypacksarebestchargedattemperaturesaround20°C,soavoidwarmlocations.Whencoming

inoutofthecold,allowthebatterypacktogetuptoroomtemperature(about20°C)beforecharging.

• Charge status indication

On battery packs with a round charging port with translucent ring, it is possible to check the charge status

manually by touching the charge connector ring to activate the charge LED. It will light up in the color

correspondingtothechargelevel:Greenfor100-85%,Orangefor85-25%andRedwhenbelow25%.

• Power supply 100-240V

The power supply will adjust automatically to the local voltage.

• Charging

Connecttheconnectorofthepowersupplytothebatterypack.

Connectthepowersupplytoanappropriatepowersource.

WARNING. Replace a damaged power cable immediately to prevent an electric shock.

InstruCtIons for use

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Trek Ride plus - E-bike Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Trek Ride plus - E-bike

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info