485388
41
Zoom out
Zoom in
Vorherige Seite
1/50
Nächste Seite
DVB T1 PVR
- 15 -
Press the TIMER button on the RCU.
If you have not yet entered the actual date or time you will
now be asked to so. Use the numeric keys and confirm with
OK. As soon as you have done this the following screen will
be displayed:
This list shows all of the programmed recordings.
Select an empty slot in the list with the buttons and press
OK.
Now you can enter all data for the intended timer event.
In the column "Type" you can see if the timer function is set
for once only, daily or weekly.
You have to set the target for the recording in column 7 (Path)
either to hard disk (HDD) or to an attached VCR (VCR).
Finally, select position 8 of the menu and confirm by
pressing OK. The screen will return to the "Recording List".
In "Recording List" you can check all entries.
You can edit previously entered recording data by selecting
the corresponding position in the "Recording List" with the -
buttons. Press OK and you will see the screen "Recording
Settings". Edit the changes and confirm by pressing OK.
To delete an entry, select the corresponding event with buttons in "Recording List" and press
- button. Confirm by pressing OK, or cancel the deletion by pressing Exit when the confirmation
request is displayed.
3. How to set the timer
8.3 Recording
2. Timer Recording
1. Instant Recording
To make an instant recording, press REC button on the RCU
and recording will begin. Time delay for record start may vary
between 7 and 12 seconds, depending on the HDD standby
timer setting.
A red dot as a recording icon will appear in the upper right
corner of the screen when a recording is in progress.
To stop recording, press Stop button on the remote control unit
(RCU). A window is displayed in the lower half of the screen.
Press OK button to stop recording or "Exit" button to continue
recording.
If you allocated a fixed amount of time for the Instant Recording Duration (see menu "HDD Manager",
4), the recording will be stopped after this time has elapsed. If desired, you can deactivate this
function ("OFF ")
The recording will be stored on the HDD and will be shown on the "HDD Recorded List". It can be
displayed by pressing the "List" button on the RCU.
You can use the timer function for unattended recordings on HDD or on a conventional VCR that has
been connected to the VCR SCART connector of this unit.
You also can use the timer function for automatically switching your receiver ON / OFF or changing the
TV program at a preset time in case you don't want to miss the start of a program but want to watch
another channel until then.
The timer function allows you to set up a list with all the required timer settings in which you can enter
the date and time for the receiver to be switched on and off, the program and if necessary daily or
weekly repeat of each switching operation.
If you are currently watching a program and timer switching operation is pending, the receiver reminds
you by overlaying a massage that the timer switching operation will take place in one minute. When this
time is reached, the receiver switches over to the required channel and REC is displayed on the front
display. After the preset time has expired, the receiver switches back to the original channel.
Note: A special window will display a message that a recording is due to start in one minute.
Confirm by pressing OK, or cancel the scheduled recording by pressing Exit.
41

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Triax DVB T1 PVR wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info