11
6. MODE:
According to your needs, you can choose from three different types of computer controlled ventilation. Press once and the light
for Normal lights up, press again and the light for Nature lights up. Press once more and the sleep light lights up. Choose the speed
of ventilation from “High-Mid-Low”
Note: When you start the unit, it starts working from the initial start point.
7. THE FILTER:
The ventilator can filter all noxious substances, such as dust, fibres, smoke, etc. from the outlet of airflow. Filtering the air gives
you the impression of being in a forest or at the sea.
8. OXYGEN AND NEGATIVE IONS
While in use, the ventilator can dispense into the air a large number of negative ions. Negative ions work to clean the air and
provide you with a fresh and healthy environment.
USE
1. Open the packaging and take out the ventilator. Check the contents against the list.
2. Place the ventilator on a flat horizontal surface. It must not be at an incline during use. Check that the power supply from
the mains meets the technical characteristics written on the ventilator.
3. Fill with water. If the ventilator is new or has not been used for a long time and you want to use it as a humidifier, it is
necessary to fill with water before use. Check the water level while filling. Stop the unit before filling with water to avoid
electrical breakdowns (Fig. 3). Once the water has been filled up to the maximum level, close.
4. Humidity: When the ventilator is used as a ventilator with cold air and humidity, it is necessary to add water to the tank.
Gently press the cold air and humidity button. The display light lights up to indicate that the humidifier mode has been
selected and then switches itself off.
5. Ventilation in oscillating movement: this ventilator is fitted with an oscillating movement ventilation function, moving from
left to right. Press the settings button once and the air direction display light lights up and the ventilator blows air
automatically at a constant angle of 120º. Press this button again and the function will stop. The display light will switch off
and the ventilator will blow continuously in the same direction.
6. Adjusting the ventilation direction up-down: adjust the rubber air outlet guides by hand and the airflow can be adjusted up or
down as desired.
7. Gently press the Timer button: the display light lights up to show 0.5 hours. Continue pressing gently until timer display light
goes out and the ventilator will work continuously.
8. Using the remote control: the functions of the remote control buttons are similar to those of the ventilator’s display panel. So
that it works, the infrared emitter must be directed towards the main part of the ventilator and there must be no obstacle in
between them.
9. Storing the ventilator: if the ventilator is not going to be used for a long period of time, the water tank must be emptied and
cleaned and then the ventilator needs to be run at Normal temperature for a while so that it completely dries the inside of
the unit and especially the strainer. Wrap it in a plastic bag and put it in its box.
