Bedienungsanleitung Tristar AC-5522 (Seite 7 von 72) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch)

637494

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

OPERATION

Timer setting

• Timer o: When the air conditioner is running, press the timer button,

the timer LED lamp is on, and the display will blink. Use the UP and

DOWN buttons to adjust time from 0.5h to 24h. When the set time

expires, the air conditioner turns o automatically.

• Timer on: When the air conditioner is in standby mode, press the timer

button, the timer LED lamp is on, and the display will blink. Use the UP

and DOWN buttons to adjust time from 0.5h to 24h.

• During this setting procedure, the operating modes after start can

be selected, if the cool mode is selected, the set temperature can be

adjusted simultaneously. After the set time expires, the air conditioner

starts automatically and runs in the selected operating mode.

Change of the set time

You can press TIMER once In the running process of the timer, the remain-

ing time will be displayed. Press the UP and DOWN buttons to increase/

decrease the time. If you press the TIMER button again during blinking, the

set time will be cancelled, namely timer quits.

COOL mode

!!!Attention: if the air conditioner is restarted immediately after shutdown

in the COOL mode, it will take 3 minutes before the cooling process will

start.!!!

• Press the MODE button to select the COOL mode.

• Press the UP or DOWN button to set the desired temperature in a range

of 18~30

C (64-86

F).

• Press the SPEED button to select the desired fan speed.

• After selecting COOL mode, press the SLEEP button on the

remote control to enter the SLEEP mode. The speed level will turn

automatically in the lowest mode and the air conditionor will turn o

automatically in approximate 7h.

• Press the SWING button to activate the swing function.

DEHUMIDIFY mode

• Make sure the exhaust pipe is not installed.

• Press the MODE button to select the DEHUMIDIFY mode.

• Temperature and speed are not adjustable.

• Press the SWING button to activate the swing function.

FAN mode

• Press the MODE button to select the FAN mode.

• Press the SPEED button to select the desired fan speed. In this mode

press SPEED for “5 seconds” to run the internal dry function, i.e. both

upper and lower fans work simultaneously. Press SPEED for another “5s”

to cancel the internal dry function. Make sure the exhaust pipe is not

installed during this mode.

• During the fan mode the temperature is not adjustable.

• Press the SWING button to activate the swing function.

Cautions:

• When water full indication light comes on, the air conditioner will stop

work, you should drain the water like described further in the manual.

After drainage the air conditioner will start automatically.

• If your room faces the sun directly, please close the curtains.

DRAINAGE OPERATION FIGURE 8.

• When water full indication light comes on, the air conditioner will stop

work, you should drain the water.

• Place the air conditioner on a place where you can drain the water

directly (such as toilet or sewer).

• Unscrew the nut and pull out the plug. Install the plug and nut before

use.

Air conditioner

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Tristar AC-5522 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info