Bedienungsanleitung Tristar LF-4719 (Seite 5 von 52) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

495483

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

ENGLISH

TOPCOM Ultrasonic Humidifier LF-4719

4 Display and buttons

(see folded cover)

a. Remote control receiver LED

b. Humidity level indication

c. Empty water tank indication

d. Warm mist indicator

e. Ozone button (Ionizer)

f. Mist intensity button

g. Warm mist button

h. Timer button

i. On/off button

j. Humidity level button

k. Ionizer (Ozone) icon

l. On/Off icon

m. Timer indication

n. Room temperature indication

o. Mist intensity indication

The enclosed remote control has the same

butto

ns as the front panel. The icons are the

same.

5 Installation

• Put the humidifier on a flat surface in the room

for half an hour. It is important that it reaches

the ambient temperature and humidity.

• We recommend using the humidifier at a

temper

ature between 5 and 40°C and a

relative humidity of less than 55%.

• Remove the water tank from the

humidifier.

• Turn the water tank up side down.

• Unscrew the filter cap by turning it counter

clockwise.

• Fill the water tank with clear water (maximum

40°C

• Close the cover by turning filter

cap clockwise.

• Verify the cleanliness and water tightness and

then ge

ntly put the & water tank back on the

base.

• Position Fume dispenser in the desired

direction.

• Plug the power cord in the main power wall

connector with dr

y hands.

6Operation

6.1 On/off

• Press the on/off button on the unit on the

remote control to activate the humidifier. The

isplay lights up and, after a few seconds, the

ambient humidity is displayed.

• Press the on/off button again to deactivate

the humidifier.

6.2 Empty water tank

If the water tank is empty, the empty water tank

indication is displayed.

6.3 Humidity level control

• Press the humidity level button to increase

the humidity setting from 45% to 90%. After

flashin

g for 5 seconds, the LCD display shows

the level of ambient humidity .

When the moisture level reaches the pre-set

value,

the humidifier automatically stops for

five minutes in order to test the humidity in

the air.

• Instead of selecting the humidity level 45% to

0%, go one step above 90% for continuous

operation

6.4 Warm mist

If the water gets stagnant, it will spray the

stagnant water, and any bacteria it contains, into

It is recommended to use soft (distilled -

low-mineral) water to minimize lime

scale on the transducer.

Do not remove the water tank when the

humidifier is connected to the main

power.

When you remove the water tank after

usage, the

re will still be water in the

water flume.

Remove the water from the tank and

flume whe

n it is not used for a long

period.

Clean the water box, spray mouth and

ter flume if the humidifier is not used

for a long period.

Do not position the humidifier near heat

sources or dire

ct sunlight.

Do not aim the fume dispenser to

fur

niture, electronic equipment or baby

beds.

The ideal comfort RH for a human

eing is 40 to 60％RH

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Tristar LF-4719 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info