Bedienungsanleitung Tristar ST-8911 (Seite 5 von 60) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch)

483963

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

BEFORE THE FIRST USE

• Before the rst use, please remove any sticker or protective cover.

• Place your steam generator on a stable, horizontal heat-resistant

surface.

• For the rst use, use the iron on an old piece of fabric to ensure the

soleplate and water tank are completely clean.

• Never use the steam generator when water tank is empty, rell it

before use it again.

Fill the water tank

• Before lling the water tank, check if the steam generator is cooled

down, if the power cable is unplugged and if the temperature knob is

on its minimum position.

• Note: never unscrew the boiler cap before these three steps are done.

• During lling please do not exceed the maximum water capacity (0.5L).

• Note: use a funnel to ll the boiler.

• Please read carefully our advices in chapter “type of water to use”

concerning the water to use with your steam generator.

• Open the boiler lter cap and ll the boiler with water.

• Screw the boiler lter cap tight.

• Notes: if the water tank indicator illuminates and there is no steam the

water tank is empty.

• Never unscrew the boiler cap when the appliance is still connected to

the power supply.

Select the temperature

• Place the iron on its base.

• Select the desired temperature by using the thermostat knob, check the

ironing symbols on your clothes in order to adapt the ironing temperature.

• Note: we advise you to read the chapter “Ironing of your linens” in order

to select the best ironing temperature.

STEAM IRONING

Note: For the rst use, use the iron on an old piece of fabric to ensure the

soleplate and water tank are completely clean.

• Fill the boiler and select the temperature as described before.

• Plug the power cable into the wall outlet.

• Turn on the device by using the ON/OFF button, the unit will be heated up.

• It will take around 5 minutes to produce enough steam, the steam

ready and empty water tank indicator light will be illuminate when the

iron is ready for use.

• Note: Do not use the steam function before the steam ready indicator

illuminates.

• There are two ways to obtain steam,

o Press on the steam switch button beneath the iron handle and keep

it pressed. The steam will stop when you release the button.

o By pressing the steam lock button steam and slide the steam lock

backwards, the iron will steam now constantly.

Note: The rst time the steam generator is used, there may be some smoke

and smell, this is not harmful. They will not aect the performance and will

disappear rapidly.

AFTER USE

• Put the temperature knob on minimum position.

• Turn o the device by using the ON/OFF button.

• Unplug the power cable.

• Wait until the steam generator and the soleplate are cooled down

completely.

• Unscrew the boiler cap and pour out the remaining water then place

the boiler cap back on the unit.

Steam generator iron

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Tristar ST-8911 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info