Start-up
Push the vacuum hose into the opening of the dust compartment until it clicks in
mechanically.
In order to remove the hose again, press the two clamps inwards while pulling at the same
time.
Put the suction tube or other accessory onto the handle.
Using the unit
1. Install the accessory.
2. Unwind the necessary amount of cable, put the mains plug into a 230 V 50 Hz
mains socket and switch the unit on.
3. Push the round on/off button and with the same button set the vacuum strength
with the suction strength controller.
4. Start vacuuming at a constant speed. It is not necessary to press. Check that
you have not come to the end of the cable.
Suction control (click-stop settings):
Low suction strength: for curtains and delicate materials
Medium suction strength: for deep-file velvet carpets and delicate carpeting
High suction strength: for ordinary carpets and floors.
Winding device for the power cable:
Unwinding: Pull out the length that you require. A marking shows the maximum length on
the cable. Do not pull any further! The winding device could be damaged otherwise.
Winding in: Hold the cable firmly to prevent it from whipping around. Press the carrying
handle for cable winding and guide the cable in.
Nozzle sets:
Narrow nozzle: for vacuuming in corners and grooves,and for the cleaning of
shelves, furniture, lampshades, etc.
- Floor nozzle: to clean carpets or flat surfaces
The floor nozzle is adjustable for the current use.
Carpet: press down with your foot on the lever with the symbol for rough surfaces.
Smooth floor: press down the other lever. The levers change over.
Undoing the units: pull them apart while twisting slightly.
Emptying of the dust compartment:
Remove the plug from the socket. Open the dust compartment. Take off the dust
compartment. Clean the compartment over a dustbin: Careful: do not throw away the
filter !
Also clean the filter. Replace the filter ias you found it. Make sure that it is into place.
Replace the compartment till it snaps into its place.
Air outlet filters:
From time to time you should check the outletfilters on both sides.Lift up high the covers on
the sides; clean the filter and replace it. To close, press the cover until it snaps into place.
