Bedienungsanleitung Tronic KH 3002 (Seite 6 von 14) (Englisch)

464846

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

- 4 -

• Do not operate the Energy Station in the im-

mediate vicinity of sources of heat, such as an oven,

hot air blowers (in a vehicle: close to heating

vents) and similar appliances! Heat effects could

lead to the equipment overheating and to the

melting of plastic parts, whereby the Energy

Station could be irreparably damaged!

If it is overheated, the Energy Station could

be irreparably damaged and the risk of

a fire exists!

• This appliance must not be placed in the im-

mediate vicinity of flammable materials,

for example curtains, inflammable liquids etc.

• Do not place any open sources of fire,

like candles, on the appliance.

Injury hazard!

• Keep children away from the connecting cable

and the appliance. Children frequently under-

estimate the dangers of electrical appliances.

• Ensure that the appliance stands with a safe and

secure positioning.

• Do not operate the appliance if it has sustained

a fall or is damaged. Arrange for the appliance

to be checked and, if necessary, repaired by

qualified technicians.

Start-up

The Energy Station is supplied with a low-level pre-

charged battery. Prior to initial usage it must therefore

be charged.

Attention!

The battery can lose considerable capacity should

you use the Energy Station without fully charging it

beforehand!

• Before taking the appliance into use, check to

ensure that the Energy Station, the connection

cables

 and the power supply unit  are in

a defect-free condition.

Danger!

NEVER use a damaged connection cable. Risk of

short circuit!

Charging with the mains power plug

Attention: Explosive Gas

Avoid flames and sparks. During charging, ensure

that there is sufficient ventilation.

1. Insert the appliance plug of the power supply

unit

 in the charging socket DC-INPUT w at

the back of the appliance.

2. Connect the power supply unit

 to a mains

power socket. The mains voltage must conform

with the specifications on the ratings plate of the

power supply unit.

3. Place the main switch 2 at the front of the appli-

ance to the “CHA” position. The Energy Station is

now being charged.

4. While the Energy Station is charging, the red LED

“On” 6 in the field CHARGE will be illuminated.

5. When the battery is nearly fully charged, the

green LED “Full” 6 will start to be faintly illumi-

nated. As soon as it is fully illuminated you can

remove the power supply unit

. The red LED

"On" 6 continues to glow until you place the

main switch 2 in the position "OFF".

Charging with the vehicle adapter

You can also charge the Energy Station by con-

necting the supplied vehicle adapter

 to the

12V on-board voltage system of a motor vehicle or

sports boat:

1. First insert the appliance plug of the 12V vehicle

adapter

 in the charging socket w at the rear

of the appliance.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Tronic KH 3002 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Tronic KH 3002

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info