Bedienungsanleitung Trotec DH 105 S (Seite 10 von 16) (Englisch)

580109

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

9 Operating manual — Condenser dryer DH 105 S EN

The accurate functionality of the device was tested during

production a number of times. However, if functionality faults do

occur, then check the device according to the following list.

Note!

The device is provided with a safety timer. Switch-on and

switch-off can be up to 3 minutes delayed.

The device does not start:

• Check the power connection.

• Check the mains plug for damages.

• If the fault indicator for the condensate pump lights up or a

beep is emitted, have the error repaired by a specialist

company for cooling and air-conditioning or by TROTEC

• Have the electrics checked by a specialist company for

cooling and air-conditioning or by TROTEC

The device runs but forms no condensation:

• Check the condensation drain hose is positioned correctly.

• Check that the condensate pump functions properly. Check

for abnormal vibrations and sounds. Remove external dirt.

• Check the room temperature. Check the device's permissible

operating range complies with the technical data.

• Ensure that the relative humidity complies with the technical

data.

• Check that the selected relative humidity is realistic. Relative

humidity in the room where the device is positioned shall be

at least 3 % above the nominal value. If necessary, reduce

the set relative humidity.

• Check the air filter is not dirty. If necessary, clean or replace

the air filter.

• From the outside, check the condenser and the condensate

pump are not dirty (see Maintenance chapter). If the inside of

the device is dirty, have it cleaned by a specialist company for

cooling and air-conditioning or by TROTEC

The device is loud or vibrates; condensate is leaking:

• Check whether the device is standing upright and on an even

surface.

The device gets very warm, is loud or is losing performance:

• Check the air inlets and air filter are not dirty. Remove

external dirt.

• From the outside, check the inside of the device and

especially the fan, the fan housing, the evaporator, the

condenser and the condensate pump for dirt (see

Maintenance chapter). If the inside of the device is dirty, have

it cleaned by a specialist company for cooling and

air-conditioning or by TROTEC

Error messages

Your device still does not operate correctly after these

checks? An error number is still shown in the display of your

device?

Bring the device to a specialist company for cooling and

air-conditioning or to TROTEC

for repair.

Errors and faults

Error numbers Meaning

E1 Temperature error:

The temperature is outside the tolerances. The device

operates automatically in dehumidification and

defrosting cycle until the temperature is within the

tolerance range again.

E2 Error message of the humidity sensor:

The relative humidity is outside the specified values. The

device operates in continuous operation mode until the

value is within the tolerance range again.

E3 Wrong rotating field: Correct the rotating field on the CEE

phase inverter.

E4 Phase missing: Check mains voltage.

E5 Communication fault

E6 Undervoltage protection:

Check mains voltage.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Trotec DH 105 S Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Trotec DH 105 S

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info