Bedienungsanleitung Trotec DH 110 BX (Seite 8 von 19) (Englisch)

580105

Zoom out

Zoom in

Vorherige Seite

1/19

Nächste Seite

EN Operating manual – Condenser dryer DH 75/110 AX/BX 7

Danger!

A falling device can cause injuries! Always utilize the

help of another person to transport and assemble the

device. Never stand below the device when suspended

in the air.

Behaviour in the event of an emergency

1. Disconnect the device from the mains power in an emergen-

cy.

2. Do not reconnect a defective device to the mains power.

The manufacturer packed the device to the best of his abilities to

protect it against transport damages. Further information regard-

ing safe transport is to be found in form of multilateral signs on the

packaging.

Always transport the device with the help of another person. To lift

the device, use a fork lift or an elevating truck.

Before transporting the device, proceed as follows:

1. Only have an electrically skilled person disconnect the power

cable!

2. Remove the condensation drain hose and any residual fluid

from it.

After transporting the device, proceed as follows:

1. Set the device in an upright position after transport.

2. Wait one hour before switching the device on!

Only have the power cable connected to the terminal block of

the control box (underneath the protective cover) by an

electrically skilled person!

Storage

When out of use, store the device as follows:

•dry,

• with a roof overhead,

• in an upright position where it is protected from dust and di-

rect sunlight,

• with a plastic cover to protect it from invasive dust, if neces-

sary.

• The storage temperature is the same as the range given for

the operating temperature in the chapter Technical Data.

• After being switched on, the device operates fully automati-

cally.

• So that the built in sensor can correctly detect the relative hu-

midity, the fan continues to operate until the device is

switched off.

• Avoid open doors and windows.

Positioning

When positioning the device, observe the minimum distance from

walls or other objects as described in chapter Technical Data.

• Set the device in a level and stable position.

• When positioning the device, keep a sufficient distance away

from sources of heat.

• When positioning the device in wet areas, secure the device

locally with an RCD (Residual Current protective Device) which

complies with the appropriate regulations.

• Ensure that extension cords are completely unrolled.

Notes regarding the dehumidification performance

Dehumidification performance depends on:

• the spatial composition of the room

• the room temperature

• the relative humidity

The higher the room temperature and relative humidity, the higher

the dehumidification performance.

For using in living rooms, a relative humidity of approx. 50-60 %

is sufficient. In store rooms and archives, the humidity should not

exceed approx. 50 %.

Transport

Operation

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Trotec DH 110 BX Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Trotec DH 110 BX

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info