Bedienungsanleitung Trotec PAC2100X (Seite 15 von 21) (Englisch)

688783

Zoom out

Zoom in

Vorherige Seite

1/21

Nächste Seite

EN 15

local air conditioner PAC 2100 X / PAC 2600 X

The device works with reduced or no cooling capacity:

• Check whether cooling mode is selected.

• Check the proper fit of the exhaust air hose. In case of

kinks, bends or blockage in the hose, exhaust air cannot

be discharged. Clear the way for the exhaust air.

• Check the position of the ventilation flaps. They should be

opened to the maximum.

• Check the air filter(s) for dirt. If necessary, clean or replace

the air filter(s).

• Check the minimum distance to walls or other objects.

Position the device a little more in the room's centre

if required.

• Check whether any windows and/or doors of the room are

open. If so, close them. One window has to remain open

for the exhaust air hose nonetheless.

• Check the temperature setting at the device. Reduce the

set temperature if it is higher than the room temperature.

The device is loud or vibrates:

• Check whether the device is set up in a stable and upright

position.

Condensate is leaking:

• Check the device for leaks.

The compressor does not start:

• Check whether the overheating protection of the

compressor has tripped. Disconnect the device from the

mains and let it cool down for approx. 10minutes before

reconnecting it.

• Check whether the ambient temperature equals the target

temperature (in cooling mode). The compressor will not

switch on unless the respective temperature is reached.

• The compressor may start up with a delay of 3minutes, as

it is provided with an internal protection against direct

restart.

The device gets very warm, is loud or loses power:

• Check the air inlets and air filters for dirt. Remove external

dirt.

• From the outside, check the device for dirt (see chapter

Maintenance). If the inside of the device is dirty, have it

cleaned by a specialist company for cooling and

air-conditioning or by Trotec.

The device does not respond to the infrared remote control:

• Check whether the distance between remote control and

device is too large and reduce it if necessary.

• Make sure there are no obstacles, such as furniture or

walls, between the device and the remote control. Ensure

visual contact between device and remote control.

• Check the charging status of the batteries and change

them if required.

• If the batteries have only just been changed, check them

for correct polarity and change them if required.

• Check whether the remote control is still in standby mode.

Standby mode can be terminated by pressing the

ON/OFF button(28) on the remote control.

Note

Wait for at least 3 minutes after maintenance and

repair work. Only then switch the device back on.

Your device still does not operate correctly after these

checks?

Please contact the customer service. If necessary, bring the

device to a specialist company for cooling and air-conditioning

or to Trotec for repair.

Error codes

The following error messages can be displayed in the segment

display(15):

Error code Cause Remedy

E1 Fault at

temperature

sensor

Disconnect the device briefly

from the mains.

Should the error still be

displayed after the restart,

please contact the customer

service.

E2 Fault at humidity

sensor

E4 Fault at control

panel

P1 Condensation

tank full

Empty the condensation tank.

Should the error still be

displayed, please contact the

customer service.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Trotec PAC2100X Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Trotec PAC2100X

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info