Bedienungsanleitung Trotec PAC3000 XA plus (Seite 16 von 27) (Englisch)

727660

Zoom out

Zoom in

Vorherige Seite

1/27

Nächste Seite

16 EN

local air conditioner PAC 3500 SH / PAC 3000 X A+

Errors and faults

The device has been checked for proper functioning several

times during production. If malfunctions occur nonetheless,

check the device according to the following list.

The device does not start:

• Check the power connection.

• Check the power cable and mains plug for damages.

• Check the on-site fusing.

• Observe the operating temperature according to the

Technical data chapter.

• The condensation tray may be full. Empty the condensation

tray if necessary. The error codeP1 must not be indicated

on the segment display.

• Wait for 10minutes before restarting the device. If the

device is not starting, have the electrics checked by a

specialist company or by Trotec.

The device works with reduced or no cooling capacity:

• Check whether cooling mode is selected.

• Check the proper fit of the exhaust air hose. In case of

kinks, bends or blockage in the hose, exhaust air cannot

be discharged. Clear the way for the exhaust air.

• Check the position of the ventilation flaps. They should be

opened to the maximum.

• Check the air filter(s) for dirt. If necessary, clean or replace

the air filter(s).

• Check the minimum distance to walls or other objects.

Position the device a little more in the room's centre

if required.

• Check whether any windows and/or doors of the room are

open. If so, close them. One window has to remain open

for the exhaust air hose nonetheless.

• Check the temperature setting at the device. Reduce the

set temperature if it is higher than the room temperature.

The device is loud or vibrates:

• Check whether the device is set up in a stable and upright

position.

Condensate is leaking:

• Check the device for leaks.

The compressor does not start:

• Check whether the overheating protection of the

compressor has tripped. Disconnect the device from the

mains and let it cool down for approx. 10minutes before

reconnecting it.

• Check whether the ambient temperature equals the target

temperature (in cooling mode). The compressor will not

switch on unless the respective temperature is reached.

• The compressor may start up with a delay of 3minutes, as

it is provided with an internal protection against direct

restart.

The device gets very warm, is loud or is losing

performance:

• Check the air inlets and air filters for dirt. Remove external

dirt.

• From the outside, check the device for dirt (see chapter

Maintenance). If the inside of the device is dirty, have it

cleaned by a specialist company for cooling and

air-conditioning or by Trotec.

The device does not respond to the infrared remote control:

• Check whether the distance between remote control and

device is too large and reduce it if necessary.

• Make sure there are no obstacles, such as furniture or

walls, between the device and the remote control. Ensure

visual contact between device and remote control.

• Check the charging status of the batteries and change

them if required.

• If the batteries have just been changed, check them for

correct polarity.

Note

Wait for at least 3 minutes after maintenance and

repair work. Only then switch the device back on.

Your device still does not operate correctly after these

checks?

Please contact the customer service. If necessary, bring the

device to a specialist company for cooling and air-conditioning

or to Trotec for repair.

Error codes

The following error messages can be displayed on the segment

display(16):

Error code Cause Remedy

P1 Condensation tank

full

Empty the condensation

tank. Should the error still

be displayed, please

contact the customer

service.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Trotec PAC3000 XA plus Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Trotec PAC3000 XA plus

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info