Bedienungsanleitung Trotec PAGS10-125 (Seite 10 von 20) (Englisch)

753914

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

10 EN

angle grinder PAGS 10-125

Information on noise and vibration:

• The vibration level specified in these instructions was

determined by means of a measuring method standardized

in EN60745 and can be used for a device comparison. The

specified vibration emission value may also be used for a

preliminary assessment of the exposure.

Caution

Vibration emissions can cause a health hazard if the

device is used for an extended period of time or if it is

not properly handled and maintained.

• The vibration level will change depending on the

application of the power tool and may in some cases differ

from the value specified in these instructions. The vibration

load may be underestimated if the power tool is used

regularly in such a way. For a precise estimation of the

vibration load during a certain work period, it is also

important to consider the periods during which the device

is switched off, or is running but not actually employed.

This can reduce the vibration load over the entire work

period significantly.

Transport and storage

Note

If you store or transport the device improperly, the

device may be damaged.

Note the information regarding transport and storage of

the device.

Transport

For transporting the device, use the transport case included in

the scope of delivery in order to protect the device from external

influences.

Before transporting the device, observe the following:

• Switch off the device.

• Hold onto the mains plug while pulling the power cable out

of the mains socket.

• Allow the device to cool down.

• Remove the tool from the tool holder.

Storage

Before storing the device, observe the following:

• Switch off the device.

• Hold onto the mains plug while pulling the power cable out

of the mains socket.

• Allow the device to cool down.

• Remove the tool from the tool holder.

• Clean the device as described in the Maintenance chapter.

• For storing the device, use the transport case included in

the scope of delivery in order to protect the device from

external influences.

When the device is not being used, observe the following

storage conditions:

• Dry and protected from frost and heat

• Ambient temperature below 45°C

• Protected from dust and direct sunlight inside the transport

case

Start-up

Unpacking the device

• Take the transport case out of the packaging.

Warning of electrical voltage

Electric shock from insufficient insulation.

Check the device for damages and proper functioning

before each use.

If you notice damages, no longer use the device.

Do not use the device when the device or your hands

are damp or wet!

• Check the contents of the transport case for completeness

and look for damages.

Warning

Risk of suffocation!

Do not leave the packaging lying around. Children may

use it as a dangerous toy.

• Dispose of the packaging material according to the

national regulations.

Mounting the handle

Caution

Only use the device with the supplied additional

handle.

The additional handle(9) must be mounted before start-up.

To do so, please proceed as follows:

1. Screw the additional handle(9) clockwise into the

thread(2) either on the right- or left-hand side or on top of

the housing.

2. Check the additional handle(9) for tight fit.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Trotec PAGS10-125 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Trotec PAGS10-125

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info