Bedienungsanleitung Trotec PHDS11-20V (Seite 5 von 19) (Englisch)

753273

Zoom out

Zoom in

Vorherige Seite

1/19

Nächste Seite

EN 5

cordless hammer drill PHDS 11-20V

•During operation hold onto the power tool with both

hands. Make sure that you stand firmly on the ground. It is

safer to handle the power tool with two hands.

•Secure the workpiece. The grip of tensioning devices or a

vice is more secure than holding the workpiece only by

hand.

•Before starting to work, always make sure that the

insertion tool is firmly clamped inside the drill chuck.

Insertion tools that are not locked in place could be

catapulted out of the power tool upon switch-on and lead

to injuries.

•Before switching on the power tool, ensure that the

insertion tool can move freely. If the device is switched

on with a jammed insertion tool, the resulting forces can

be extreme causing the device to kick out sideways.

•Immediately switch off the power tool if the insertion

tool blocks. The power tool can lash out to the side owing

to the forces that build up consequently.

•Regularly check the drill chuck for wear or damage.

•Only start a percussive power tool while holding it

against a workpiece (wall, ceiling, etc.).

•Wait until the power tool has come to a standstill,

before putting it down.

•For any work on the device, as well as during transport

or storage, set the switch for the rotational direction to

centre position (locked). This prevents unintentional

starting of the power tool.

Safety instructions when using long drill bits

•Never operate at higher speed than the maximum

speed rating of the drill bit. At higher speeds, the bit is

likely to bend if allowed to rotate freely without contacting

the workpiece, resulting in personal injury.

•Always start drilling at low speed and with the bit tip

in contact with the workpiece. At higher speeds, the bit

is likely to bend if allowed to rotate freely without

contacting the workpiece, resulting in personal injury.

•Apply pressure only in direct line with the bit and do

not apply excessive pressure. Bits can bend causing

breakage or loss of control, resulting in personal injury.

Intended use

Only use the device PHDS 11-20V:

• for screwing in and loosening screws,

• for drilling in wood, plastic, ceramic and metal,

• for impact drilling in masonry, bricks and stone,

whilst adhering to the technical data.

We recommend using the power tool with original Trotec

accessories.

Foreseeable misuse

The device is not intended for drilling in natural stone.

Any other use than the one described in the chapter "Intended

use" is regarded as reasonably foreseeable misuse.

Personnel qualifications

People who use this device must:

• have read and understood the instructions, especially the

Safety chapter.

Safety signs and labels on the battery

Note

Do not remove any safety signs, stickers or labels from

the device. Keep all safety signs, stickers and labels in

legible condition.

The following safety signs and labels are attached to the

battery:

Warning of explosion risk!

These symbols indicate the following:

Do not expose the battery pack or tool to fire or

excessive temperature! Do not let the battery come into

contact with water or fire! Avoid direct sunlight and

moisture. There is a risk of explosion!

Never charge the battery at ambient temperatures

below10°C or above40°C. Charging improperly or at

temperatures outsides the specified range may damage

the battery and increase the risk of fire.

Observe the correct disposal of the battery!

This symbol indicates the following:

Ensure that the battery is disposed of correctly and

never dispose of it in waste water or public waters.

The battery contains irritating, caustic and toxic

substances that pose significant risks to people and the

environment.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Trotec PHDS11-20V Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Trotec PHDS11-20V

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info