Bedienungsanleitung Trotec PT6500S (Seite 15 von 26) (Englisch)

688814

Zoom out

Zoom in

Vorherige Seite

1/26

Nächste Seite

EN 14

air conditioner PT 6500 S / PT 15000 S

Errors and faults

The device has been checked for proper functioning several

times during production. If malfunctions occur nonetheless,

check the device according to the following list.

Wear safety glasses

For start-up, maintenance and troubleshooting always

wear suitable safety glasses.

Wear protective gloves

For start-up, maintenance and troubleshooting always

wear suitable protective gloves.

Wear foot protection

For transportation, start-up, maintenance and

troubleshooting always wear suitable foot protection.

The device does not start:

• Check the power connection.

• Check the power cable and mains plug for damages.

• Check the on-site fusing.

• Observe the operating temperature according to the

Technical data chapter.

• Check whether the green operating light is illuminated.

If not, check the power connection and the plug. The fuses

inside the plug and/ or on the mainboard might be

defective.

In case of defective fuses also check the points listed

under the error message HIPS.

• Wait for 10minutes before restarting the device. If the

device is not starting, have the electrics checked by a

specialist company or by Trotec.

The device works with reduced or no cooling capacity:

• Check whether cooling mode is selected.

• Check the proper fit of the exhaust air hose. In case of

kinks, bends or blockage in the hose, exhaust air cannot

be discharged. Clear the way for the exhaust air.

• Check the air filter(s) for dirt. If necessary, clean or replace

the air filter(s).

• Check the minimum distance to walls or other objects.

Position the device a little more in the room's centre

if required.

• Check whether any windows and/or doors of the room are

open. If so, close them. The window for the exhaust air

hose has to remain open nonetheless.

• Check the temperature setting at the device. Reduce the

set temperature if it is higher than the room temperature.

• Also check the points listed under the error message HIPS.

The device is loud or vibrates:

• Check whether the device is set up in a stable and upright

position.

Condensate is leaking from the basic device:

• Check the device for leaks.

The compressor does not start:

• Check whether the overheating protection of the

compressor has tripped. Disconnect the device from the

mains and let it cool down for approx. 10minutes before

reconnecting it.

• The compressor may start up with a delay of 3min, as it is

provided with an internal protection against direct restart.

The device gets very warm, is loud or loses power:

• Check the air inlets and air filters for dirt. Remove external

dirt.

• From the outside, check the device for dirt (see chapter

Maintenance). If the inside of the device is dirty, have it

cleaned by a specialist company for cooling and

air-conditioning or by Trotec.

Note

Wait for at least 3 minutes after maintenance and

repair work. Only then switch the device back on.

Your device still does not operate correctly after these

checks?

Please contact the customer service. If necessary, bring the

device to a specialist company for cooling and air-conditioning

or to Trotec for repair.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Trotec PT6500S Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Trotec PT6500S

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info