Bedienungsanleitung Trotec PWLS10-20V (Seite 6 von 10) (Englisch)

753922

Zoom out

Zoom in

Vorherige Seite

1/10

Nächste Seite

6 EN

cordless work light PWLS 10 / PWLS 10-20V

Transport and storage

Note

If you store or transport the device improperly, the

device may be damaged.

Note the information regarding transport and storage of

the device.

Transport

Before transporting the device, observe the following:

• Switch off the device.

• Allow the device to cool down.

• Hold onto the mains plug while pulling the power cable of

the charger out of the mains socket.

• Remove the battery from the device.

The supplied Li-ion batteries are subjects to the requirements of

dangerous goods legislation.

Observe the following when transporting or shipping Li-ion

batteries:

• The user may transport the batteries by road without any

additional requirements.

• If transport is carried out by third parties (e.g. air transport

or forwarding company), special requirements as to

packaging and labelling must be observed. This includes

consulting a dangerous goods specialist when preparing

the package.

– Only ship batteries if their housing is undamaged.

– Mask open terminals with tape and pack the battery in

a way that it cannot move inside the packaging.

– Please also observe any other national regulations.

Storage

Before storing the device, observe the following:

• Switch the device off.

• Hold onto the mains plug while pulling the power cable of

the charger out of the mains socket.

• Allow the device to cool down.

• Remove the battery from the device.

• Clean the device as described in the Maintenance chapter.

• Do not store Li-ion batteries which are completely

discharged. Storing discharged batteries can lead to a

deep discharge and thus damage the battery.

When the device is not being used, observe the following

storage conditions:

• dry and protected from frost and heat

• Ambient temperature below 40°C

• protected from dust and direct sunlight

Start-up

Unpacking the device

• Take the device and the accessories out of the packaging.

Warning of electrical voltage

Electric shock from insufficient insulation.

Check the device for damages and proper functioning

before each use.

If you notice damages, no longer use the device.

Do not use the device when the device or your hands

are damp or wet!

• Check the contents for completeness and look for

damages.

Warning

Risk of suffocation!

Do not leave the packaging lying around. Children may

use it as a dangerous toy.

• Dispose of the packaging material according to the

national regulations.

Charging the battery

Note

The battery can be damaged in case of improper

charging.

Remove the charger's mains plug before inserting or

removing the battery.

Never charge the battery at ambient temperatures

below 10°C or above 40°C.

The battery is partially charged upon delivery to avoid damage

to the battery caused by a deep discharge.

Prior to initial start-up and when the battery is low (only the red

LED in the battery level indication(8a) is illuminated), the

battery should be charged. To do so, please proceed as follows:

1. Slide the battery(8) into the quick charger(9) upside

down.

1 h

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Trotec PWLS10-20V Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Trotec PWLS10-20V

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info